20 Most Recent Black & Decker 9072CTN 2.4V Cordless Screwdriver - Page 6 Questions & Answers

If you made sure all locks are undone, spray apenatration fluid like DW40 or Q20 on any parts that need to hinge or slide.

Put the clutch on a high number, put the reverse on, hold the chuck tightly, lightly press the triger. If it does not come undone, make the clutch tighter (loer number).

You need to lift it slightly when pulling it out.

http://www.maxusacorp.com/pdf/o_manual/cn80_manual.pdfFrequent but not excessive... 2-3 drops in the air inlet.

Either the pressure release valve is loose or the seals are worn out. Make sure the screw valve is tight. If that doesn't fix the problem, buy another jack. The seals really aren't user replaceable.

go to the manufacturers site and see if you can down load a pdf file or see if you can enter the details direct

Remove the HT lead and clean around the area with a good electrical contact cleaner. Look for cracks in the insulation around the HT lead. Replace the Boot around the lead or replace the lead. Clean out the inside of the terminal. The spark is tracking down some dirt/ moisture or crack. If the coil is cracked replace the coil.

This tool is available from good auto spares stores make sure by 2 as they have to be either side of the spring and good quality as your fingers will be damaged if poor quality ones slip

Try a good hardware store for extension springs for the job. Take the broken one along as a sample.

You can try loosing them off a little and use some lubricant as well say spray lithium grease or wd-40 or crc.

Go to yahoo.com

Go to Yahoo.com and type in the manual you are looking for.

Wrenches and sockets.

Go to Yahoo.com and type in the manual you are looking for.

You need to call a tech. It could be low on Freon, maybe sensing valve, may be dirty coils. There are a number of things it could be.

Go to Yahoo.com and type in the manual you are looking for.

You can't.

Check bearings or bushings

Go to Yahoo.com and type in the manual you are looking for. it will tell you how to fix the trigger

Go to Yahoo.com and type in the manual you are looking for. Or go to Youtube.com and post the above questions.