20 Most Recent
Emerson MW8102SS 1100 Watts Microwave Oven - Page 4 Questions & Answers
My problen is the mico
I would think it possible.
Remove the outer cover when the machine is unplugged and follow the mains lead in through the rear panel. There should be a couple of fuses nearby.
Always use the correct value fuse of identical type and size!
Hope that helps.
Its not working when i set the time to cook its
In a no heat situation, it is quite common to find the door safety interlock switches have failed. Remove the cover, find the switches and check them for proper operation with a volt/ohm meter. These switches are how the oven knows if the door is closed or not. If the oven cannot confirm the door is closed, it will not turn on the heat.
Thank you for your question @ FixYa.copm
Just got today brand new
if its the initial start of the heating of the microwave that you are refering to then you may have a damaged keypad this couldve happened at the factory hopefully you still have the reciept and are able to take it back and exchange for a new one.
My Emerson MW8102SS burned a
You can use the old one as a pattern and cut a new one out of a sheet of universal waveguide material.
The part number for that is 40QBP1012 (or if that's not available, 40QBP1618). You can order that by part number from
the Pros here.
We're happy to help you with free advice and we'd appreciate your thoughtful
rating of our answer.
Turn table stopped working on
The Turntable motor is defective and will need to be replaced, you can contact the manufacture for the part, or call in a appliance repairman to fix the problem.
The 2 screws on the bottom of the stainless steel
You need a "nut driver" -- probably either 3/16, 1/4, or 5/16 ". If you have one of those 5-in-1 screwdrivers you see at shopping counters almost everywhere these days, one of the nut drivers on it will probably fit.
Charlie
The start button is not working-everything else
Sorry to read about your problem.
It seems your have a general failure in the power control or switch failure on the unit. Since your unit has power, and things lite. it is more likely you have a control/switch problem,
Careless troubleshooting of a microwave oven can result in death or worse. Experienced technicians have met their maker as a result of a momentary lapse of judgement while testing an oven with the cover removed. Microwave ovens are without a doubt, the most deadly type of consumer electronic equipment in wide spread use.
The power supplies for even the smallest microwave ovens operate at extremely lethal voltage and current levels. Do not attempt to troubleshoot, repair, or modify such equipment without understanding and following ALL of the relevant safety guidelines for high voltage and/or line connected electrical and electronic systems.
Microwaves must be serviced by technicians due to the inherent dangers involved in repairing these appliances. Internal capacitors can retain a lethal electrical charge even though the unit is completely unplugged. A microwave radiation leakage test must be performed on the unit following any internal component repair.
I tried to help you. Please help me and Rate/Vote on my response, thanks and good luck
4 Thumbs - Very Helpful
3 Thumbs - Helpful
2 Thumbs - Somewhat Helpful
1 Thumb - Not Helpful
Not finding what you are looking for?
