Kenmore 14.8 cu. ft. / 419 liter Chest Freezer 11531 - Answered Questions & Fixed issues

0helpful
1answer

What is proper setting for upright freezer. my kenmore had setting at 0 degrees from factory. is that correct?

That should be ok. However -10 is more common.
1/30/2013 6:16:05 PM • Kenmore 14.8 cu.... • Answered on Jan 30, 2013 • 97 views
0helpful
1answer

Kenmore chest freezer makes loud banging noise once in awhile what the problem

What is the model number of your unit?
11/22/2012 12:27:48 PM • Kenmore 14.8 cu.... • Answered on Nov 22, 2012 • 262 views
0helpful
1answer

Kenmore 2539280412 upright wont stay cold

Check the thermostat of your Kenmore Dryer.For More information please visit Dryer Parts.
11/14/2012 7:37:01 AM • Kenmore 14.8 cu.... • Answered on Nov 14, 2012 • 92 views
0helpful
1answer

Not a problem, just a

The basic principle on which a "Freezer" works would dictate that the answer to your question is "Yes", it would still "Freeze". It's what it's designed to do, as opposed to a refrigerator, which works on a different principle. http://home.howstuffworks.com/freezer2.htm
7/2/2011 6:24:10 AM • Kenmore 14.8 cu.... • Answered on Jul 02, 2011 • 152 views
0helpful
1answer

I have a kenmore upright

I keep min two notches from the coldest setting.A great way to check where you should set yous,is ice cream.Put an open container of ice cream in the freezer,and turn the freezer to coldest.The next day try to scoop the ice cream.If the ice cream is hard the freezer is too cold.Adjust the freezer two notches ,and try the ice cream the next day.Repeat till you are happy with the hardness of the ice cream.It should be easy to scoop but not too soft.
5/17/2011 2:09:56 PM • Kenmore 14.8 cu.... • Answered on May 17, 2011 • 459 views
0helpful
1answer

Meat is frozen but ice cream is soft

Hi,
As the weather is getting warmer for many people their freezer2_bing.gif and/or refrigerator do not work right because of a dirty condenser coil...

Check out this tip that I wrote about that... it is a great place to start trouble shooting your unit...and something that you can do rather then calling a repair person to do a simple thing for you...

Refrigerator2_bing.gif Condenser Coil Cleaning Refrigerator2_bing.gif Repair
http://www.fixya.com/support/r4024657-refrigerator_condenser_coil_cleaning

Refrigerator Troubleshooting2_bing.gif Refrigerator Compressor
http://www.fixya.com/support/r3885294-refrigerator_troubleshooting

Refrigerator Compressor Start Capacitor and Start Relay
http://www.fixya.com/support/r4023749-refrigerator_compressor_start_capacitor

heatman101
8/12/2010 3:41:23 AM • Kenmore 14.8 cu.... • Answered on Aug 12, 2010 • 1,212 views
0helpful
1answer

Is it safe to plug a typical Kenmore

Safety is not an issue, the problem you may have, depending on the surge protector, is that when the compressor starts up the amps drawn from the circuit is very high which could cause the surge protector to trip, then the power would be shut off to the refrigerator,NOT A GOOD THING!
Good luck !
1/28/2010 8:17:27 PM • Kenmore 14.8 cu.... • Answered on Jan 28, 2010 • 330 views
0helpful
2answers

Sears Kenmore Deep Freezer settings

i tilt my chest kenmore deep freezer to remove water when cleaning it by the time it was connected it didnt work
1/21/2010 5:53:58 PM • Kenmore 14.8 cu.... • Answered on Jan 21, 2010 • 2,506 views
0helpful
1answer

Can I plug my freezer into a surge protector

i know where your going and its a good thought
read your compressor, it will label the start up amp,
it may even be on the model label
it will give you the rated amps and the start up amps
this is current draw to run
as well as start up a stopped motor
depending on the age
most units use about
short of that use a 3x method
if it has the run amp x3 is startup
then read your surge protector if its rated higher than the amps needed to start the unit
then you should be fine
i will say most SP are rated at 15amps
my freezer is rated at 18amperes
10/17/2009 6:54:43 PM • Kenmore 14.8 cu.... • Answered on Oct 17, 2009 • 5,815 views
0helpful
1answer

My freezer sounds like its on, but it wont freez.

if the compressor is warm that is an indication to me that it is running or at least trying to run. if its running you should feel it vibrating as well as being warm. assuming the compressor is running and it's not cooling I would say you probably have a refrigerant leak and would come out cheaper to replace the unit. repalceing the compressor also is fairly expensive in exess of 300-400 dollars. Let me know if you have any other questions Peyton
3/8/2009 2:23:22 AM • Kenmore 14.8 cu.... • Answered on Mar 08, 2009 • 215 views
0helpful
2answers

Used chest freezer not cooling

chest freezer operation is among the simplest available. if the compressor is running and its not cooling there are only 2 possibilities. low or no refrigerant and or a bad compressor. so if you have the ability to return the unit I would. could luck peyton
2/1/2009 12:30:43 PM • Kenmore 14.8 cu.... • Answered on Feb 01, 2009 • 828 views
0helpful
1answer

Freezer/kenmore

the settings usually are:
off - on - superfreeze. you just want "on"
11/16/2008 11:47:52 AM • Kenmore 14.8 cu.... • Answered on Nov 16, 2008 • 358 views
0helpful
1answer

The thermostat is out on my Kenmore 14.8 cu ft freezer

I asked a local repair shop. Just pull ******* the sensor wire and it will slip out of the tube through which it runs. Run the new wire which is attached to the new thermostat thru the same tube. Prior to purchasing the thermostat, I tested with a ohm meter for continuity ( there was none) and jumped the attaching power wires. The compressor ran verifying the problem with the thermostat. Thermostat cost $47.00.
6/8/2008 5:34:01 PM • Kenmore 14.8 cu.... • Answered on Jun 08, 2008 • 489 views
0helpful
2answers

Compressor Stops on Kenmore Chest Freezer

sounds like the temp control has begun to acquire oxidation on the contacts inside of it. When you tap near it, there is just enough impulse vibration for the spring-loaded contact points to help the electricity to find a path through the oxidation. If you feel strong one day, take it apart and polish the metal contacts to remove the oxidation. Then re-assemble it and re-connect the wires. Should be good as new again. Second option...replace the control dial unit. Most contact points in electronics are designed to have a "wiping" effect when they are actuated thus removing any oxidation from the mating surfaces.
2/12/2008 3:19:49 AM • Kenmore 14.8 cu.... • Answered on Feb 12, 2008 • 342 views
0helpful
1answer

Kenmore chest freezer cubic ft 253.16082108

19.7 cu. ft.

Kenmore 1608 - Elite 19.7 cu. Ft. Chest Freezer Use And ...

ManualsLib https://www.manualslib.com > manual > Kenmore-1608... View and Download Kenmore 1608 - Elite 19.7 cu. Ft. Chest Freezer use and care manual online. Use and Care Guide. 1608 - Elite 19.7 cu. Ft. Chest Freezer ..
4/10/2024 8:08:12 PM • Kenmore Freezers • Answered on Apr 10, 2024 • 13 views
0helpful
2answers

Error code b on kenmore chest freezer

LOW / NO BATTERY ALARM The Low/No battery alarm will activate when the power level of the battery becomes low. The display will alternate between "b" (Battery, See figure 8) and the cabinet temperature, the red alarm light will become illuminated and the control panel will beep every five seconds. To stop the audible alarm (beep), press the "ALARM RESET" button. The red alarm light will remain on and the display will continue to flash until a new battery is installed. This same alarm will activate if there is no battery installed
2/18/2024 3:02:00 PM • Kenmore Freezers • Answered on Feb 18, 2024 • 178 views
0helpful
2answers

Kenmore upright freezer. The alarm keeps going off?

The light may be staying on and creating heat, or the unit thinks the door is still open. Or the door seal is worn and is letting cold out. Or It needs gas. Have you put a thermometer inside to check the temperature? It should be 0'F +/- 2'. https://www.google.com/search?q=Kenmore+upright+freezer.+The+alarm+keeps+going+off ..
1/20/2024 10:41:55 AM • Kenmore Freezers • Answered on Jan 20, 2024 • 40 views
0helpful
1answer
0helpful
3answers

Kenmore Elite 25326082101 freezer. The FF sign is on and the Reset is lit. Freezer is not working. What can I do?

Question edited for full 'make model (what it is). Question moved to Maker category. 'FF' is Fast Freeze. Do a Power Reset. Disconnect from the mains for 5 minutes and plug back in. If that doesn't fix it, you will need a service call. It may have leaked refrigerant gas.

Kenmore Elite 25326082101 upright freezer manual

https://www.searspartsdirect.com > manual > kenmore-... Download the manual for model Kenmore Elite 25326082101 upright freezer. Sears Parts Direct has parts, manuals & part diagrams for all types of repair ...
10/30/2023 1:29:32 PM • Kenmore Freezers • Answered on Oct 30, 2023 • 128 views
0helpful
2answers

My kenmore upright freezer has frozen water at the bottom and is leaking frozen at the top also. how and I fix it

It sounds like you might be dealing with a defrost drain issue or a problem with the freezer's door seal. Try defrosting the freezer and clearing any ice buildup, then check the door seal for any gaps or damage. If the problem persists, you may need to consult the user manual or contact a professional appliance repair service for assistance.
8/18/2023 8:36:22 AM • Kenmore Freezers • Answered on Aug 18, 2023 • 62 views
Not finding what you are looking for?
Kenmore 14.8 cu. ft. / 419 liter Chest Freezer 11531 Logo

Popular Tags

35 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Freezers Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Kenmore Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...