2001 Honda XR 250 R "carb float setting" Questions

...valve in the carb. It could also be that the float is not properly set. the float in the bowl needs to be properly angled to allow the required amount of fuel to enter the carb when it is

...float level, etc., are set as they should be. Please don't be upset with me. I just don't want you to tinker with the carb until it is broken. Problems will come soon enough. Enjoy your bike and fix ...

...float bowl. With the carb inverted, take off the float bowls. Take off the gasket. Use a vernier caliper or an accurate device to measure from the carb body to the top of the float block. Here is are ...

...too heavy. Replace float. New carb, check float setting,can be set too high from factory. Check carb bowl and under needle for trash. Any trash in bowl or under needle, clean snd add fuel

...float needle open. Clean out carb, adjust floats so when it shuts off fuel flow, float is parallel to base of carb. Blow through fuel pipe on carb and lift floats with your hand, you should not be ...

...float assembled in the carb, hold the carb on it's side with the needle and seat hinge upwards. Set the float height to 0.630" to 0.670" (16-17mm) from the "bottom" of the float to the gasket surface ...

...the carb, take off the bottom float bowl on the carb. Then while holding the carb upside down, you want to set the floats level. You will have to bend the little tab on the float needle to do

...carb, the float level has to be set with the carb on an angle. To illustrate this, I'd have to send you a picture. I'd be glad to do so if you're contact me directly as this forum only allows a file ...

Float level setting on Mikuni carb, 30-32 DIDTF Mitzi L200. Remove the float bowl on the carb. Hold the carb upside down, the set the floats level.

...float to the lower face of the carb body with the carb tilted at an angle of 15 - 20°. A picture is worth a thousand words in this case. For a picture, contact me directly at wd4ity at ...