Black & Decker Pivot Plus Cordless Drill/Screwdriver "bits" Questions

My bit in my drill is stuck into a large tree stump... that had been cut close to the ground. How can I get the bit unstuck? My dewalt drill is unable to drill in & drill out. My 1" width bit

...The steel ball is held in place by the sleeve that slides up and down to release the ball so the bits can be changed. The sleeve is held down by a spring. Bits falling out can be caused by: Using ...

Ryobi Impact wrench won't release bit won't release bit from wrench I would spray a little bit of WD-40 while pointing the bit up towards the sky. The fit is very tight and any rust can jam the bit. ...

My rattle gun 18V LXT Impact Driver BTD141 has a double ended Philips stuck in it? how do i get it out? There are a couple of ways to try to free the bit from the drill chuck. But slow and steady is ...

...When I pull back to release it it will not come out. Do you have any sugestions? Hi, Yes.... the bits can "spin" just a bit and will jam in the chuck sometimes... Grab the bit with a large pliers ...

I have drilled a 1 inch hole in my concrete basement wall. I cannot release the bit from the drill. The chuck won't turn by hand to release the bit. Good Afternoon, Ladooudep55: I hope you have got ...

which drill bits for b&d cordless I have a b&d cordless drill hp9096 9.6v though no drill bits. Can I use any make or are there specific bits I should buy. Thanks you can use any brand of bit ...

...WH 18 DFL cordless impact driver, which I love. It has the quick release system for changing bits. I was doing a little bit of heavy drilling, and now the drill bit is stuck. The sleeve

I cannot get the drill bit's to stay in my dewalt D25003 drill, do I need special bits or an adapter? Are you using a SDS bit in this tool? If so you might have a problem with the bit lock mechanism, ...

How do i fasten the the drilling bit in the machine ? For the pictured drill motor, you put the bit in and use a "chuck key" to tighten the chuck onto the bit... If the photo is not your machine but ...