orbital sander doesnt orbit! I use orbital sanders in my work daily .Ihave a craftsman and a Makita 6 inch orbital sander.When I replaced the pads, [on both of them] when I started them up, they didnt
7336 orbital sander how to replace sanding pad If you are talking about the actual sanding pad itself it should just pull of .If you are talking about the backing pad it should un screw
...replace; remove the screw in the center of the pad and remove it. Depending on which is tighter, the bearing will either be in the back of the pad or it will stay on the armature. Pry it off/out of ...
...I have had to replace the "pad" and now when I start the sander the screws (3) that hold the pad on tighten to the point the sander will not rotate. Any ideas? Use some loctite thread locker on
Question about Tools & Hardware - Others
replace velcro pad on rupes random orbital sander need to know how to replace velcro pad please I have replaced velcro on various sanders , you just take the original velcro off and make sure that the
Question about Dewalt Tools & Hardware - Others
replace sanding pad on random orbital sander dw443 How do you get it apart? You will find usually 3 torx drive screws on the bottom of the tool, remove them and the pad comes off. The replacement pad ...
...is the most common resolution to this problem? random orbit sander 333-5" motor runs but the disk dose not turn Hi, The main drive belt broke. Not hard to replace, it is under the disk pad. Good
...pad with a Porter Cable 13910, sold as compatible. Now the sander takes off, ie: increases speed with reduced control and overheats quickly. It sounds like a bearing issue. Is this coincidence or can ...
Question about Makita Tools & Hardware - Others
makita random orbit 5". The pad flew apart. Is it replaceable ? I don't see a bolt or screw holding it on. Usually there are 3 screws holding the plate to the eccentric assembly. The pad is formed to ...
8 questions posted
Usually answered in minutes!
27 Questions
14 Questions
12 Questions