...idle speed control valves in jag XJ6 GIVE PROBLEMS often?i think mine might be faulthy in my 95 model.any help would be great.... Hi the idler valve has a set up with jag equpment but there is a way ...
...set-up and it has been fine for the last 2 years. Also with the idle doing what it did it had a very harsh shift when driving and changing gears. The BAD news is the dealer has to perform the engine ...
...idle speed motor is set, then it could have an effect on idle speed if the sensor is bad. The position sensor is just a fancy potentiometer. Hope some of this helps. It sounds very much like a map ...
...set for several minutes before it starts up again. I don't think that it is getting fuel. I think that I need to change the fuel pump, but I'm not sure where it is located. in the fuel tank I have ...
Question about Chevrolet Cars & Trucks
...set and idle for a while it starts idling up and down.any idea's? I have a 1990 S-15 with 4.3 motor idles high when you start, idles down , set and idle for a while it starts idling up and ...
...set the idle to 700rpm with the grub screw stop just above where the throttle cable fits to the throttle body. Reconnect theidle control valve and you're done. It may take a few k's driving ...
...set but it is not, is this some kind of sencer problem? It sounds like your Idle Control Valve is stuck. Remove the Idle Control Valve on the throttle body and clean out the holes, and clean the Idle ...
idle air control set up passages get plugged an don't allow enough air to by pass the throttle plate causing stalling problems . A vacuum leak can cause a ruff unstable idle an stalling also . A dirty
Question about Saturn Cars & Trucks
...idle is set at the factory an you need not try to adjust it ! You will cause running problem an the check engine light to come on . Try cleaning the throttle plate and the idle air control passages . ...
...idle air speed is set at the factory with a stop screw. This setting allows a certain amount of air to bypass the throttle valves regardless of IAC valve pintle positioning. A combination of this air ...
787 questions posted
Usually answered in minutes!
375 Questions
210 Questions
172 Questions
129 Questions
83 Questions