2004 Infiniti G35 Sport Coupe "resetting worn brake pad light" Questions

...worn and I replaced with a premium ceramic pad (car was braking fine). I had no problems replacing the front and rear pads and did not have to bleed the brakes at all. After the job was complete, I ...

...brake pads that have an electrical connector.. the warning light comes on when the pad is so worn that it allows the electrical connector to earth via the disk .. hence the warning light. Fitting new ...

...brake worning light hi i have changed fron brake sensors the pads are fine. the worning light is not going off. I have tried the reset procedure. thanks check the brake fluid level if its low the ...

...I want to reset the light indicator low fluid level will keep the light on also the pad wear sensors need to be replace once the pads have worn down to the sensor they are not resetting

on;;AWD still works tho. Sounds like you need new brake pads , when the pads get worn it triggers the warning replace the brake pads reset the computer this should fix the noise and the warning lights

...brake pads were worn enough to activate the warning light the sensor or sensors must be replaced. There is no reset for this. have u tried taking hot side of battery cable loose for a few min resting ...

...Worn brake pads; Worn calipers (beyond tolerance); Defective ABS unit; Low brake fluid level; Defective master cylinder; Brake fluid leak. It is important that whatever condition is causing the ABS ...

...dont know how to reset pad lining wear indicator When you replace the brakes on a Car like this you should also replace the sensor otherwise the Worn Brake warning light is not going to switch

...worn brake pad warning light on my volkswagen transporter, the pads have been replaced it cannot be reset. there is a sensor on one of the brake pads which has a connector on it and the connector ...

...brake pads too far down and the light is why you had the brakes inspected and replaced then the sensor on the caliper has been worn thru. You will need to replace the part. The light should go of as ...