...stream of coolant...very few bubbles.Warm the engine for 5 -10 min.shut it off.remove the spark plugs.If you can see steam or water vapor you're in trouble...the head must come off to inspect for a ...
...stream of water then try the heat. If the thermostat is working properly, then a heater control valve would need replacing. If the valve is behind the glove box, where it is in most cars you could ...
glove box to get to the Blend Door Motor, but after turning the air from hot to cold at various speeds, the motor appears to be working. What should I look at next? Does the air blows through the dash
...stream of coolant the air is out. If you still have no heat it could be an issue with the doors in the evap unit. Remove the glove box and check to see if the doors move when you use the controls. If ...
...stream of water running out the overflw tube by fire wall. It looks like water and has no odor. Help! The A/C - Heater issue is a stuck blend door or blend door motor issue. This often happens when ...
...stream from the running lights as the dash lights being out is the teltail that the tailights are out. The fuse is hot all the time and the wire from the fuse goes straight to the headlight switch. ...
...box and gently pull the new one out and compare it to the old one. Make sure that all the fittings are in the same place. As a side note here it is usually wise to replace the radiator cap and ...
Question about Honda Accord
...them , I keep spares in the glove box. It can be cleaned out with care fuse of sewing needed. toyota sells them on there parts pages for this exact car. can be order on line after p/N is
stream is always at the max temperature. This is true for all settings of the flow direction control. (Vent, defrost, floor etc) remove glove box then on heater case look for the temp door actuator if
2,046 questions posted
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions
