1989 Jeep Comanche "attach hose disconnects" Questions

...control vacuum line is disconnected and has a 90 degree fitting on end but cannot find location it attaches to. has vacuum when engine is started. jeep does not have cruise control and hose comes ...

...Attach the radiator bolts and brackets. Tighten the radiator bracket bolts to 7 ft. lbs. (10 Nm). Connect the coolant reservoir overflow hose. Connect the automatic transaxle cooling lines to the ...

...attach the three attaching screws. Tighten to 60-85 inch lbs. Connect wiper motor's wiring connector. Install wiper linkage clip to the motor's output arm. Connect the washer nozzle hose and install ...

...point of the other hose on the engine. or just get a fitting( simply a piece of pipe from an autoparts store) to attach both hose ends ( from the firewall) together, thereby bypassing the heater

change a heater core how to change a heater core Disconnect battery ground cable. Remove glove box attaching screws, then the glove box. Remove lower sound insulator attaching screws and nuts, then ...

HEATER HOW DO I REMOVE THE HEATER CORE ON A 94 D VILLE Disconnect battery ground cable. Remove glove box attaching screws, then the glove box. Remove lower sound insulator attaching screws and nuts, ...

...connector from coolant sensor. Remove throttle body cooling hose. Remove thermostat housing attaching bolts, then remove thermostat housing and thermostat. INSTALL OR CONNECT Thermostat. ...

heater core replacement Hello Fred. Not a real easy job to do but if you want to tackle it, good for you. Here is the manual instruction. Disconnect battery ground cable. Drain cooling system. Remove ...

...clamps, and clamp around pump body Pull pump assembly out of rubber connectors Inspect fuel pump attaching hose for any signs of deterioration. Replace as necessary. Install or Connect: Push fuel ...

...hose to the pump, then attach the pump to the bracket and tighten to 22-25 ft. lbs. (29-34 Nm). Engage the connector to the fuel pump. Install the fuel sending unit to the pump bracket. Install the ...