...92 Ford ranger xlt 3.0 v6 The spark plug firing order is ( 1 - 4 - 2 - 5 - 3 - 6 ) The distributor rotor turns CLOCKWISE ( 1 - 4 - 2 - 5 - 3 - 6 ) The marked # 1 position on the distributor cap faces ...
where is the thermostat housing on my 92 ranger 2 wheel drive 2.3 liter. Follow the top hose from the radiator to the engine and there it is.
...92 ford ranger custom,v6, 3.0 engine. I've had it for 5 years and didn't have a problem til i replaced the starter 2 years ago with a rebuilt starter. Now, since last summer when i turn it over when ...
...2 yrs. ago it's a 92 ford ranger dual cab If the heater core is leaking, you would get a lot of steam that would smell "sweet". That would also leave you low on coolant, which could be a source of ...
92 Ford Ranger 2.3L 2wd that wont start. when you put the clutch in and turn the key it just clicks. so i went out and replaced the battery cables, battery, soleniod relay (on fire wall) ,and starter,
92 is missing like its timing is off but i just put new plugs n wires but it only does it on takeoff and then it smells like it overloads on gas if any body might have some advice please help stranded
Question about Ford Ranger
...92 ranger,OLD. 50 causes (parts) its caused by misfire, so bad it stalls. 1 cause) 5 reasoins if physics and simple tests. lost 12vdc to PCM (voltmeter) lost compression hot, (cam slip time) or lots ...
92 ranger 3.0L V6. It ran great for 2 days, then the tranny went. I had the entire transmission rebuilt, and it ran great for a couple of weeks. Now the truck will not start. I have pulled and had the
...2) you can check the resistance of the coil on both the primary and the secondary sides for correct resistence 3) check the wires for shorts etc, which prob aint the wires 4) you can do a compression ...
1,000 questions posted
Usually answered in minutes!
645 Questions
573 Questions
562 Questions
558 Questions
477 Questions