1988 Chevrolet K1500 "crank position sensor 88" Questions

...model. Also, check the wiring to that sensor. Some vehicles have problems with the crankshaft pulley harmonic balancer failing and damaging either the body of the crank position sensor or its

...crank angle/position sensor near the crank pulley. A photo of the sensor is attached. The sensors wear out due to heat and cold cycles and internal corrosion. MasterPro Ignition - Crankshaft Position ...

1988 volvo 740 gle where is the crank sensor where is the crank sensor in a 88 volvo 740 gle on the bottom belt pully at a 5 o-clock position

crank saft position sensor Where would the position sensor be located? How diffcult is it to change the part. I think it is on the bell housing of the transmision when you replace it you have to set ...

...replaced the crank shaft position sensor and spark plugs,and fuel filter and allot of other things, but not the knock sensor or the Mass air flow sensor...where can I locate the knock

...driven without problems to work and after work wouldn't start. Only has 76,000 original miles. Any ideas of what to check next? Crank position sensor...i have same car and that happened to ...

looking for directions for the crank positioning sensore What would you like to know ?It is located on the timing cover near the crank pulley.

...to save my life. It's a 88 lebaron Bad crank position sensor or fuel pump. Check fuel pressure at engine compartment where it goes into fuel injection. If OK, usually bad crank postion

WHERE IS 88 S-10 2.5 CRANK SENSOR LOCATED ? According to my data I see the following. The Crankshaft Position Sensor is located: This vehicle is not equipped with selected component

position sensor stop it from getting spark and i checked all te fuses Bill Yes the cam sensor could fail to send a signal to the ignition module, but a V6 engine does not use a cam sensor. It does use