...power.If the blower motor has power then pull and wiggle on the blower motor resistors pigtail or connector but make sure the heater and fan motor and the ignition switch are turn on so you can here ...
...getting power to resistor, with a test light if power is at resistor, check and see if you are getting power at blower motor if no power there replace resistor. But if you have power at motor replace ...
Question about Chevrolet Silverado 2500HD
...power then the blower motor is at fault.If no power at the fan use the lighter socket to get 12v to give the blower motor to guarantee its just a power supply issue.If blower works you will need to ...
Question about Chevrolet Silverado 2500HD
...power directly to the motor to verify fan motor runs- if it doesn't the motor may need replacement/repair. BLOWER MOTOR RESISTOR USUALLY LOCATED ADJACENT TO THE BLOWER MOTOR UNDER THE DASH ON ...
...the interior fan speed control unit, still can't get the fan going did you check the climate control module,check first if you are getting power to the blower motor and go from there.
Question about Chevrolet Silverado 2500HD
...power at blower resister which is mounted next to fan motor.You should have power on two wires,one coming from switch the other going to fan.If you have power going to resister ,the resister is bad ...
...power, if the blower resistor has no power, fuses or blower relay are the most likely cause. if the blower resistor has power but still no fan, most likely your fan has failed. as a general rule, I ...
...Getting hot air but no power from the fan, defrost is terrible, need more power from fan There is a blower motor under the dash, behind glovebox. Loosen 3 retaining screws holding motor housing, drop ...
...getting power and i just replaced the fuse With the ignition and fan switches turned on check for power at fan motor.If you have power at the motor then wiggle and maybe pull on the blower motor ...
Question about Chevrolet Silverado 2500HD
...getting power to common blower relay terminal. Fan runs on all speeds when 12V is sent to blower motor. Why power loss to common relay terminal. IS there a way to ope "selector switch" is OK. Power ...
819 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions