blower motor resistor keeps getting hot and blowing This caused by a defective blower motor, the current draw on the blower resistor is excessive and this leads to excessive heating of the blower ...
...blower motor for power.If the blower motor has power then pull and wiggle on the blower motor resistors pigtail or connector but make sure the heater and fan motor and the ignition switch are turn on ...
Question about Chevrolet Silverado 2500HD
...blower motor has gone bad. The highest setting 5 has no resistor, so the blower runs on high but the high current flow ends up burning up the switch's contact on that setting or the relay and may be ...
...Blower motor not working .changed resister.. still nothing checkrd fuses. have 12 volts on red and black wires at resistor.. no other wires at resistor have power even with blower switch on. The ...
Question about Chevrolet Silverado 2500HD
My AC level 1 and 2 wont blow but 3, 4 and 5 all work fine. 2002 Chevy Silverado 1500 My guess is a bad resistor for the blower motor. you will need a new blower resistor and harness for resistor
Question about Chevrolet Silverado 2500HD
blower motor resistor. It is located under the dash on the drivers side near the blower motor. This should help http://www.fixya.com/cars/r6571076-blower_motor_not_work I replaced the resister 4 times
Question about Chevrolet Silverado 2500HD
blower motor that is under the dash for the heater is control by what is called a resistor. it is a small gadget with a plug on top with 2 or 3 wires. The resistor will give out sometimes and needs to
fan motor doesn't work in position 1 or 2 but works in3,4,5 Probably the blower motor resistor pack has gone out. You need to replace the blower motor resister.
blower motor resistor location under the passenger side of the dash there will be a trim panel. Remove that panel. You will then see the blower motor and the resistor right nest to the blower motor. ...
blower motor does not work on high. motor would not work at all. changed out the resistor and all but high (5) will work. Hello, you will need to replace blower control resistor mounted under the ...
819 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions