1985 Nissan Pickup "rear end feels sliding turning" Questions

...rear wheels and place Park brake ON 2) Jack up front end and use Jack Stands. If you dont have Jack Stands, you can use the Car Jack but when you remove the tire, slide the tire under the vehicle so ...

...rear end is sliding. ??? check your rear wheel tire pressures. low pressure will give you that sensation. also check your rear tire(s) condition, worn tires can cause that sensation. if tire pressure ...

...rear end differential may have slack in it. Rear end will make noise if it has a problem. Could be a bent slide in axle. Jack it up and spin it with wheel on. If 2wd jack up back and put it in drive. ...

...end is sliping to the right what could it be one of the two problems i already know about or somthing new replacing the rear shocks will fix your problem,, you can't see it when your driving, but ...

rear of the car slides to the right and i feel like the back end is going to fall off. this started after having the car strapped down on a flat bed truck to be towed. i was told i need to replace the

...rear bumper.Position the center lift point of the jack under the center of the spare tire. 7.Turn the wrench clockwise to raise the jack until it lifts the end fitting. 8.Continue raising the jack ...

...rear end MAYBE YOUR BRAKES ARE DRAGGING Ok I think your spindle bushings in the rear are broken the squealing is from the tire rubbing against either the strut or rear control arm with the car on the ...

...end, this enables you to ratchet the piston back "IN" to it's original position. Either way you can only turn clockwise regardless of the tool. It will be tough, but not impossible. You should ...

could do the same using a length of rope with slip knots on each end. under the rear of the vehichle the spare tire is in the rear under the van, the release to lower it is under the cargo area carpet

...end of the bulb into the lamp assembly. You may need to turn the bulb left or right to align the grooves in the plastic base with the tabs in the lamp assembly. When the grooves are aligned, push the ...