2002 Pontiac Grand Am "gm 3 intake bolts" Questions

3) are correctly aligned: http://gsi.xw.gm.com/image_en_us/gif/000/002/003/2003412.gif Use a 24 mm wrench to rotate the camshaft slightly, until exhaust sprocket aligns with the camshaft. Hand tighten

...GM 12486572) intake and vortec heads. What is correct torque for intake manifold bolts? 25 ft/lbs The correct procedure is as follows. Step 1- Torque bolts to 71 inch pounds. Step 2- Torque bolts to ...

...3 steps. these are low torque fasteners, don't over tighten & use locktite. If reusing the fasteners, apply threadlock GM P/N 12345382 or equivalent to the threads of the lower intake manifold ...

...GM P/N 12345382 (Canadian P/N 10953489) or equivalent and apply to the old intake manifold bolt threads. IMPORTANT: Manufacturer recommends the center bolts be fully torqued before the diagonal bolts ...

...3.5 the map sensor is located on the rear(left side of motor) of the upper intake manifold under the black bracket that the spark plug wires are routed over. You have to remove the two upper intake ...

...it is bolted to the black plastic intake of the engine, open the hood and on driverr's side, has 3 or 4 large connectors Source(s): gm master tech ...

...GM parts Schram auto & truck parts # 1-800-292-1032 I just did the same,yes you have to remove the power steering pump,alternator,idler and the belt tent. Not so bad though, if you rotate the ...

...gm ok. good luck and ps the intake pushrods are shorter than the exhaust pushrods and there is no clearance if you get them in wrong an apprentice found this out 3 years ago and a lot of people saw ...

...3. Remove accessory drive belt. 4. Remove front cover as follows: a. Remove coolant reservoir or surge tank. b. Attach engine support tool Nos. J-28467-360 and J-28467-400, or equivalents, onto ...

...3.4L V-6 Engine (VINs J, E - RPOs LG8, LA1) were known to have intake gasket failure. This was due to a bad gasket that was designed by GM...it had nylon in it...Over 400,000 of these were sold in ...