1997 Oldsmobile Regency "install front oil seal" Questions

...oil from the transmission?? A leaking rear main seal will not cause your transmission to leak. The transmission has its own seal and should not leak because of the engine rear main seal. Due to the ...

...the seal. Install the sprocket without disturbing the Woodruff key. Install the timing belt and front covers. Connect the negative battery cable to the battery. Start the engine and check for ...

...Install the front cover gasket, cover, and bolts onto the engine. Install the front cover-to-oil pan bolts and do not overtighten. Tighten the cover bolts finger tight and do not overtighten. J41480 ...

...front cover seals Install a new rear main bearing cap oil seal Install new oil pan side gaskets on the block Make sure the tabs of the front and rear seal fit properly as these are critical spots ...

front axle support. - Unfasten oil sump screws at transmission and engine ends. - Lower and remove oil sump. Sealing faces clean and free of seal debris. Apply approx.3 mm wide, 2 mm high coat of Drei

...seal along the camshaft front end and install by driving the installer with a hammer until the oil seal is pulley seated. 6.Install the camshaft sprocket and tighten the bolts to the specified

...front face of the cylinder block. Remove the gasket tabs. Clean the timing case cover, oil pan and cylinder block gasket surfaces. Remove the crankshaft seal oil seal from the cover by prying it out ...

Install: Lubricate the front seal and the sealing surface of the balancer with Chassis Grease. Install the balancer onto the crankshaft lining up the index key. Tap into place using a rubber mallet or

...out. Withdraw nozzle and wipe excess sealant off the oil pan seal groove. Install new front crankshaft oil seal. Immediately install the oil Dan. if you have an email address i can send some ...

Install front wheel hub assembly with suitable tool. • Use a new oil seal, and apply grease to seal. • Install oil seal so that it is flush with knuckle. 7. Install new oil seal with SST(0K993 331 016