1995 Oldsmobile Aurora "oil pressure sending unit" Questions

oil pressure light goes on until car warms up. Oil level is good low oil pressure light goes on and off until the car reaches full operating temperature. The car runs fine. I checked the oil level and

...pressure oil I have had this same issue. I my case the oil pressure sending units continued to fail. After replacing them 3 times I gave up and just let it go. You need to be sure it really IS a ...

...oil pressure 55,000 miles on rebuilt V6 engine. Engine runs OK at cruise speed but loses oil pressure at idle speed. Timing cover and valve cover have oil leak as well. Car is drivable but loses ALL ...

...oil pressure it has full oil and everything do you thing it is the oil pump and wherer is the oil pump on this car If the vehicle is operating normally and not knocking and making noises suspect a ...

...oil pressure .It is a 1999 V8 4.0 L . There dose'nt appear to be any oil leak . It should be on the left side of the engine(front of car) wiring runs under and around oil pan maybe wires are torn or ...

...Aurora 4.0 motor, is the Oil pressure sending unit, which is located with the oil filter, the same thing as the oil pressure sensor? They are located in different places on the motor. one and the ...

oil pressure warning. Engine running normal, there is no tapping and the oil level is where it should be. Oil needs changed according to indicator, but oil is clean. check for the oil pressure sending

...light binking on and off then going out on 2003 olds alero 3.4 oil is full probably the sending unit but it is safer to have the oil pressure checked at the rpm and temperature that this ...

oil pressure indicator at low rpms (idle) '97 olds V8 My '97 oldsV8, when warmed up, will read low oil pressure and the in-dash and audible will both come on at traffic stops. They go off as soon as I

...oil pressure is low. AT stops it can drop to 5 to 7 sometimes lower. see if your oil pressure sending unit is leaking it should be located close to the oil filter. pull the plug off the sending unit ...