...like to try resister first..suggestions? The Blower Motor Resistor is located behind the glove box on the dash. Remove the whole glove box to access. The Resistor is mounted against/sort
glove comparment and can be accessed from under the passenger's side dash. Two hex blots need to be removed from the credit card sized blower and the wiring harness disconnected. You will then have to
need to change low beam headlight, how do I remove the burned out bulb Check to see if there is access behind the lens with the hood up to twist a ring and remove the bulb that way. Compare the new ...
How to change negative battery cable 2012 Chevy Equinox 2.4 Fwd Put on safety glasses and gloves Ensure the car is turned off Locate the battery Determine which is the positive and which is the ...
...to remove the glove comparment to get at them. As always be sure you disconnect the negative cable from the battery before pulling any relays, to avoid shorting out your electrical system. Good
glove-comparment with a 4-point screw-driver. 3. The blower-motor assembly is black in color-all plastic construction, and its cylindrical in shape. Disconnect the electrical plugs that go to the side
how to change signal light Front, or rear? Front...raise hood look for inside wire connecting to the bad bulb...most bulb sockets release when twisted counter clock wise, and pull bulb assembly ...
...Some Mercedes have two filters., the second one being on the other side . Some are behind the glove box rear panel. These are difficult to replace without creasing or distorting the filters.
...need a diagram for this all you have to do is locate the 2 hoses on the firewall and then pull the glove box, and the lower panel off on the passenger side. You will have to remove the blower motor ...
1,355 questions posted
Usually answered in minutes!
1,073 Questions
901 Questions
722 Questions
711 Questions
539 Questions