1997 Buick LeSabre "ignition coil" Questions

...packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack. With Type I Ignition With Type II Ignition Hope helps (remember rated and comment

...ignition coil packs You have 3 individaul coils each one sits on the ICM(ignition control module). Now if there is no power to one of the ignition coil pack youll have to replace the ignition module, ...

...coil pack replaced they still arent firing. i was told it was the ignition module..i need to know where the ignition module is located and how to install a new one. if u can help me it would be ...

no spark on one coil ignition ignition control modular it is under the coils take off all 3 coils and there it is  

...ignition coil(s) from on top of the module...(leave plug wires attached)....and set aside noting coil position on module....unplug module and replace with a known working module.If there is grease ...

how to change ignition control module There should be 6 bolts that hold the ignition coils in place. If you remove those bolts, the coils and the module will come out. However, if stalling is your ...

...The ignition control module, should be attached by the coil pack. On a 3800 V6 they are known for the coil pack's, to go bad and misfire or not start at all. These car's do not have

...ignition coil that the # 6 plugs in to? Can an ignition coil be tested? Can the fuel injector be cleaned? The car runs smooth in idle/park and it appears to run smooth when moving above ~10 mph. ...

...coil. i just replaced my plugs and plug wires about a month and a half ago, but i went out after dark and had my wife start the car and seen a spark going through wire #4. the other two coils are ...

...coil packs. Still getting a P0300 code. Check these items. - Clogged or faulty fuel injector (s) - Intake air leak - Fuel injectors harness is open or shorted - Fuel Injectors circuit poor electrical ...