20 Most Recent 1995 Buick LeSabre Questions & Answers


hello
u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable-store and it;s actually really illustrative

1995 Buick... | Answered on Feb 19, 2019


Check all connections from the battery to the starter for both corrosion, tightness and broken wires .

1995 Buick... | Answered on Oct 15, 2018


I had the same problem with my 95 Lesabre. The owners manual says to take the key out, and wait 3 minutes(until the light goes off). It should fire right up.

1995 Buick... | Answered on Sep 26, 2018


go to the given link from where you will get the service and repair manual with diagram so that youi can fix the problem by your own and if you do not find the manual on site leave your mail id along with your need soon you will get the revert http://toolsnyou.com/

1995 Buick... | Answered on Jun 18, 2018


Unfortunately this sounds very much like a vehicles that has been neglected and has not had regular services. Take it to a repairer and ask for a quote to fix all the issues. Be prepared for bad news as it may not be worth repairing.

1995 Buick... | Answered on Jun 03, 2018


The 20A HEADLAMP CIRCUIT BREAKER is in the left underhood fuse block.

1995 Buick... | Answered on Apr 29, 2018


if it is a fuel problem check the fuel pressure regulator
if the is fuel in the vacuum hose then u need a regulator

1995 Buick... | Answered on Jan 01, 2018


You have covered all the possibilities except interference from the theft deterrent circuit or a wiring defect.

1995 Buick... | Answered on Nov 20, 2017


Sounds like the throttle body is sticking. Do not use WD40 to free it. Use some Carb cleaner on it and then oil it with some synthetic 5w30 engine oil. You may also have to clean the MAF and MAP sensors if this is fuel injected. I had a 2000 Buick Lesabre and the glue came off letting in water when driven in the rain. It would cut out till the heat from the engine dried out the water and then it would work again.

1995 Buick... | Answered on Sep 29, 2017


The Passlock family has two basic relearn procedures-a ten-minute procedure and a thirty-minute procedure-and which one you use depends on the system and what components have been replaced.

The ten-minute procedure involves trying to start the engine. If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine. If it starts and runs, everything is okay. If you get the same result as previously-nothing happens or the engine starts and dies with the security light flashing-wait ten more minutes.

You will now begin the thirty-minute relearn procedure, which is just the ten-minute procedure repeated three times. After turning the ignition off for the third time and waiting for twenty seconds, the engine should start and run. If it doesn't, there may still be something wrong with the system.

After the learn procedure is completed and the engine is running, the security light may stay on steady for a few minutes and then go off-this is normal. Depending on the system, replacement of key components will necessitate that a relearn procedure be completed. These include the ignition lock cylinder, Powertrain Control Module (PCM), Body Control Module (BCM), or Instrument Panel Cluster (IPC) ............ .Logic lock-up is an internal software issue within a control module which may be cleared by disconnecting and reconnecting the affected module (re-booting the system).

Electronic control modules can develop internal software issues which can cause erratic or no operation of the affected module. In most cases the module can be restored to proper operation by electrically disconnecting and reconnecting the affected module, just as you would reboot your home computer when it begins acting strangely.

Repeated Logic Lock-up failures of the same module would normally warrenty replacement of the affected module.

1995 Buick... | Answered on Aug 22, 2017


The complexity of the problem depends upon whether your Buick has lights with or without illuminated entry. In the former, a remote accessory control module is used in addition to an interior lamps relay position F circuit which could have a sticking relay. The "simpler" circuit has no remote accessory control module.

1995 Buick... | Answered on Jul 18, 2017


Do you have any codes in the engine control module ? When the vehicle shots off, do you think it's an electrical issue ? Of a fuel problem ?
Why did you replace the battery and starter ?

1995 Buick... | Answered on Jun 27, 2017


its time for you to find a real mechanic id say.

1995 Buick... | Answered on Jun 01, 2017

Not finding what you are looking for?
1995 Buick LeSabre Logo

1,504 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,705 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,573 Questions

1994 Buick LeSabre
1994 Buick LeSabre

891 Questions

1998 Buick LeSabre
1998 Buick LeSabre

884 Questions

1992 Buick LeSabre
1992 Buick LeSabre

764 Questions

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LeSabre Buick

  • LeSabre Buick

Most Popular Question

wire accessory tachometer 1995 lesabre

  • Cars & Trucks
Loading...