1996 Mitsubishi 3000GT "engine pulling" Questions

do i have to pull the engine to get the crankshaft out May be easier that way...you may be able to get it out by supporting engine/transaxle assembly and removing the subframe to access oil pan then ...

...it may be under the AC compressor. you will have to take off the front right tire and loosen all engine mounts. using an engine hoist, drop engine to allow room for maneuvering. disengage negative ...

...pulling out the engine for i have neither the engine stand, cherry picker nor the money to get them. So i figured I would have to do it from under neath. Do you have any suggestions? Does the engine ...

Engine Light goes on then clicking under dashboard -- engine stalls This problem just suddenly started happening. The car can run and be driven for several hours or sometimes only for a few seconds. ...

...will be minimal oil pressure developed. The oil pump will be pumping oil to the lower end of the engine and that will be where oil press if any will be developed. The rocker area has drillings ...

...I pull the alternator out of the car on a Mitsubishi GT 99 It is in a very tight spot between the engine and fire wall. disconnect battery cable remove head lamp washer reservoir tank-condenser fan ...

...to diengage the starter moter your car is now started complete the anti clockwise turn to turn your engine ...

need advice on how to pull alternator out of engine compartment not enogh room how to remove alternator on 3000 gt sohc You can get the alternator out but you need to remove all the brackets also. And

engine will randomly shut off while driving at various speeds, sometimes while idling. also security system often does not work, and sometimes activates itself and sounds alarm. 1993 Mitsubishi 3000 ...

...smoke usually means a blown head gasket or cracked head but first check the pcv valve if its stuck open your engine could be pulling in oil and burning it raw, if not good chance its your head