20 Most Recent 1996 Mitsubishi 3000GT Questions & Answers

The light will go off when the fault that caused it to go on is repaired.

Recommend remove nozzel and clean,also recommend remove resivior pump and clean screen,may have solvent jelling up.Very comon when using cheaper solvent.note always use an alchohol base solvent in resivior and make sure water jug is clean.

Diagnostic explanation is here: P1100 Diagnostic Trouble Code Discussion for Sep 2012 on iATN http://www.iatn.net/techmail/summaries/2012/09/P1100-dtc.html

BE MORE SPECIFIC!

Why do you need to trace them? Is it a stock amp? If you know where the amp is....then tracing the wiring is a cinch....

The amp has to be powered, so there's most likely a power wire from your battery. If it's a stock amp, it's powered from behind your cd player. And be more specific, what speakers? There's like what, six?

They all go to one spot man, right behind the cd player.

What's spiking? The sound? As in it's loud, quiet, loud, quiet, loud? You might have a bad ground somewhere, so check grounds. Those are easy to find, behind the deck the ground is black. If it's an aftermarket amp, then the ground is going to be close by to it. It's most likely screwed to the steel part of your car.

It could be your deck to, it might have just got randomly defective. You do have a 96 after all.

If it's an aftermarket cd player...check your wiring harness. You have to cut the wires from the car to tie them into the harness for your cd player, so jiggle those around to see if you can hear a difference.

NOT SAFE. BUY THE PART IT IS CHEAP. A FIRE IS NOT AS CHEAP

this should give you some idea HOW TO replace water pump

.may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here:http://www.xcardiag.com/

Replace the fan resistor located under dash near passenger side on the side of the heater box.

It is OBD2 and you need to scan the system for fault codes as the first step in solving the problems.

OBD2

sounds like linkadge is pinching spring.

Have you checked to see if you are getting gas?

Assuming your battery levels are good. Check fuses. Try swapping out the CAS (Crank angle sensor). If not that, try checking the coils.