2001 Oldsmobile Aurora "crankshaft position sensor relearn procedure" Questions

...crankshaft postion sensor(S) It is best to have them both replace. After replacement, a "crank position variance re-learn" procedure will need to be done to relearn the new sensors. This will need to ...

...crankshaft position sensor on a 2001 Oldsmobile Aurora with a 3.5 liter v6 If there is a relearn procedure, it has to be done with a scan tool from a shop or dealership. In most cases, the crank ...

...crankshaft position sensor replaced a crankshaft position sensor variation learning procedure should be performed the dealership has to use scanner to relearn new crankshaft sensor to the pcm so ...

...crankshaft position sensor located on a 2008 HHR 2.2 is that ecotec engine My info says it is located above the starter motor. Info says to remove the starter. The info also says you have to do a ...

crankshaft position sensor will be located on the bottom or side .. usually towards the bottom.. It will be held in place with either a screw or small bolt. Undo the screw/bolt and withdraw the sensor

...crankshaft positioning sensor , my cars turns over but won't start . What could cause this ? Did you disconnect the battery? = Anti-theft system. You need to do a relearn procedure. Or any of the ...

...crankshaft position (CKP) system variation learn procedure is required when the following service procedures have been performed, regardless of whether DTCP0315 is set:Engine ...

...Crankshaft Position Sensor ,, VERY SERIOUS THIS FIX FIRST 445 =EVAP VENTS FAIL, FIX DEAD LAST; (BASE: COMPRESSION ,SPARK ,FUEL) FOR 304 CYL, 4 MEANS SPARK LOST, INJECTOR FAILS OR COMPRESSION FAILS OR ...

...Crankshaft Position Sensor: Service and Repair Crankshaft Position (CKP) Sensor Replacement REMOVAL PROCEDURE IMPORTANT: Care must be taken when removing the crankshaft position (CKP) sensor. Use ...

oil pressure does the computer need to be reset after changing the camshaft solenoid No. If changing the crankshaft position sensor, a relearn procedure needs to be done. This requires a dealer to do.