Hotpoint Aquarius WD63 Front Load Washer/Dryer "white ball drain hose" Questions

...white ball. Is this ball suppose to be there to help the flow of water, or is the ball the problem? Hi there I suggest that some machines have that white ball to stop water from syphoning out of the ...

...white ball which floats. You will find a lot of junk here, clean out thoroughly. To refit put white cone back inside just as you found it, at the bottom, fit ball back into the cone. Attach to the ...

...white ball which floats. You will find a lot of junk here, clean out thoroughly. To refit put white cone back inside just as you found it, at the bottom, fit ball back into the cone. Attach to the ...

...ball. You will have to pop the top, remove the basket and nutate cover and unbolt the basket. If you don't have power to the new pump then check the motor controller. This will be the board on the ...

...white connector in the main PWB assembly is bad or unstable. Or the motor harness between the stator assembly and main PWB assembly is cut (open circuit) Or the hall sensor is out of order/defective. ...

...draining so be prepaired with a large towel or shopvac.check to see if anything other than the 2 white balls are in there, the white balls are sapose to be in there,sometimes a underwire gets in ...

...white ball which floats. You will find a lot of junk here, clean out thoroughly. To refit put white cone back inside just as you found it, at the bottom, fit ball back into the cone. Attach to the ...

...white connector in the main PWB assembly is bad or unstable. Or the motor harness between the stator assembly and main PWB assembly is cut (open circuit) Or the hall sensor is out of order/defective. ...

...see that it's clean, if there is white ball in it, take it out, that ball is causing more trouble than it fixes. Clean the hose where it comes together with the drum and put everything back