...then tighten the screw. Now to fix the drooping, and I assume you mean the beaters are hitting the bottom of the bowl, tip the mixer back and look into the hinge area. You will see a rather large ...
Question about KitchenAid Food Mixers
falls off into whatever is being mixed. As more time goes by the tollerance keep getting wider and now the part won't even stay on through a portion of the mixing process. there should be a lip on the
...falls into a spring latch and allows the bowl to sit flush and secure. If this is not being done, the flat beater may strike the bottom of the bowl. If this was not the cause of the problem, please ...
...to Bowl Clearance Your mixer is adjusted at the factory so that the flat beater just clears the bottom of the bowl. If for any reason, the flat beater hits the bottom of the bowl or is too far ...
Question about KitchenAid Food Mixers
...bottom of the bowl. This is causing the entire mixer jump, vibrate and shimmy til it almost falls off my counter top. I've tried to tighten up some of the screws, and now I think I have just made it ...
Question about Black & Decker Food Mixers
...go into the correct hole. The one with the collar should go into the left hole (looking at the bottom with the holes at the top) and the one without a collar into the right. The other manuals
...beater?s attachment well, to see that there is nothing; i.e. hardened food, dough or batter, in the bottom of it that would prevent the agitator shaft and groove pin from seating properly. The flat ...
...the speed controle. It is actuated by a rod conected to the outside switch that runs up the bottom of the motor drive. You'll note the simple but effective off / on switch there. When the ...
...edge trim. This uncovers the seam. Screws are on the back. Remove four visible screws from the bottom of the head around and near the pillar. Now gently using a screw driver, push the metallic ...
...hold bearing in check from moving up and down. if this works for you remember not to over tigthen bottom jam nut, lower end should move freely. post to let me know if this solves your problem.
457 questions posted
Usually answered in minutes!
493 Questions
285 Questions
205 Questions
183 Questions
89 Questions