When starting K3 GSX1000R ,red light (oil) stays illuminated & F.1 displays where temp is... what does it mean

Brake Hydraulic System Red Warning Light - RepairPal

repairpal.com/brake-hydraulic-system-red-warning-light
If the brake hydraulic system red warning light comes on and stays on, this indicates... and seems to come on and off depending on whether the vehicle is turning, ... if it is discovered that the light was illuminating due to a low brake fluid level.

This may help good luck

Reset the Oil Change Display
Instructions
1
Insert the ignition key into the ignition and turn it to the "Run" position.
2
Push the accelerator pedal all the way down to the floor and release it three times within 5 seconds.
3
Look to see if the "Oil Change" light is flashing. It will flash twice to confirm that the system has been reset. If it does not do this, start over with Step 1.
Tips & Warnings
Repeat the steps above if the oil change light stays on for 5 continuous seconds. This means that the system was not reset.

The yellow symbol with a line under it means only to warn you if the engine oil level is low when its running. If its RED sign then this is your low engine oil pressure warning light.

blinking red light means critical error check your oil if you have oil in the motor check the sensor on the oil pan! good luck! had the same problem wire was bear making contact at bottom near oil pan good luck!

I have been told this is the "dealer mode" and it might clear if you the bike off then turn the key back to the on position, but don't start the bike, turn it off then start the bike. this is supposed to reset the FI light.

To find out why it has brought this light up in the first place might require you actually taking it to a dealer, but there are lots of forums and info on this bike on the web

http://www.bugmanweb.com/gsxr/gsxrindex.html

You should be using 10W30 in summer. You may have 5 W still from the winter.

Did the temp gause go up past 1/2 way?

Need to check the ECU for registered malfunction.You must take it to a dealer's workshop.Engine warning light means that a sensor is not working properly.

Well most likey you may have a Coolant Temp Sensor concern causing it to flood but it could also be from sitting as well.The SES probally come on due to it running a bit rough after starting & set a Misfire code.The Oil Change Light Is easy to re-set.Turn Ignition on but do not start,open hood,remove underhood fuse box cover hold down the red oil-r button for 5-8 secs.then check oil change soon lamp,should be flashing.Turn Ignition off & it's reset

From left to right
1. The wrench light is the service interval light.It will illuminate after about 4800 miles or 358 days to remind you your vehicle is due for service.To reset hold the SELECT and UNITS buttons on the trip computer for 5 secs. The light will illuminate then extinguish itself after about 4 secs.
2. Frost warning light. This light illuminates yellow when exterior temps are between 39 to 32 deg. F to warn you of possible icing on the roads.It will illuminate red if temps drop below 32 Deg.
3. Brake pad warning. Will illuminate when brake pads have worn down to the sensors in the pads.
4. Washer fluid warning.
5. Door Ad-jar
6. Bulb failure. Indicates an exterior bulb is out.This will illuminate until brake pedal is pressed after starting engine unless of course one of the brake lamp bulbs is burnt out.

The negative number means the car should have had it's oil changed that many miles ago. Oil life starts at 100% for new oil & counts down every 10%. At 15% the display will always show, which means it's near time to change the oil.

usersteve83, your oil may have been changed but the timer not reset. Reset the timer as shown...
1. Turn ignition to the "ON" position. (do not start engine)
2. Press SEL/RESET repeatedly until the oil life indicator is displayed.
3. Press & hold the SEL/RESET for about 10 seconds until it blinks then let go of the button.
4. Press the SEL/RESET again for about 5 seconds or until the oil life indicator resets to 100%.

Wrench = Maintenance Minder: Symbol letter & number...
Symbol A - Relace engine oil.
Symbol B - Replace engine oil & filter, Inspect front & rear brakes, Check parking brake adjustment, Visually inpest the tie rods, suspension components,driveshaft boots, brake hoses & line (including ABS), all fluid levels & their conditions, exhaust system, fuel lines & connections.
Symbol 1 - Rotate tires.
Symbol 2 - Replace air cleaner element (dusty conditions every 15K miles) & replace dust & pollen filter (behind glovebox) every 15K miles if mainly dusty or city driving.
Symbol 3 - Replace transmission fluid.
Symbol 4 - Replace spark plugs.
Symbol 5 - Replace engine coolant.

All above are taken from the 2006 Civic EX owner's manual.