How ofden should you change oil on a crf250r 2005

Question edited for clarity.
Question moved to model category.

Torque Specifications - Honda CRF250X Owner's Manual ...

ManualsLib https://www.manualslib.com > manual > Honda-Crf250x

Honda CRF250X Manual Online: Torque Specifications. ENGINE Torque Item N•m kgf•m 1 Cylinder head cover bolts 10 1.0 2 Exhaust pipe joint nuts 21 2.1 3 10 ...

Crankcase Torque Spec.?? - CRF250R & RX

ThumperTalk https://www.thumpertalk.com > forums > topic > 8357...
Nov 5, 2010 - 12nm, 9ft lbs or 108"lbs. Don't use loctite on the case bolts. Use some blue loctite on the kick start bolt, that usually the one that comes ...

torque specs please service manual guys - CRF250X
Oct 28, 2009
Clutch cover and Crank cover Bolts/torque? - ThumperTalk
May 17, 2006
Bolt torque specs - CRF250R & RX - ThumperTalk
Aug 10, 2007
bottom end torque specs - CRF250R & RX - ThumperTalk
May 20, 2009
More results from www.thumpertalk.com

Left side cover torque specs 2005 crf 250

CRF's Only https://crfsonly.com > forum > viewtopic
Feb 25, 2012 - Hey fellow red riders I'm having to change my left side cover and can't find the torque specs for the left side cover bolts and if the ...

Torque Spex - CRF's Only Forums
Jun 21, 2007
CRANKCASE BOLTS TORQUE - CRF's Only Forums
Apr 18, 2017
Torque Specs 2006 CRF250x ? - CRF's Only Forums
Jul 1, 2009
Washers and Bolt Torque - CRF's Only Forums
Apr 9, 2017
More results from crfsonly.com

HONDA CRF250X

Honda http://owners.honda.com > 2005 > 2005_crf250x
side cover bolt (8). 6. Install the collar (7) and seat bolt (9) tighten the bolt to the specified torque: 20 lbf·ft (26 N·m, 2.7 kgf·m). Servicing Your Honda.
180 pages ..

best to replace whole throttle on handle bar with cable

http://search-manual-online.com/2005-honda-crf250r-manual.html

700ml is the amount of gear oil that you are supposed to put into this machine.
hope it was helpful?

Yes. Your bike takes two different oils. You need to get in touch with a Honda motorcycle dealership. They will be able to provide you with the oil and information you need. Honda has its own special brand of oil for each application and filters. Good Luck.

The water pump seal is maybe gone.This would allow water into the trans.Get it checked and also that the bearing hasn,t spun in its location.This may cause the color change.Being a grey color,it may indicate aluminium in the oil.This may be the spun bearing turning in the housing.With what you wrote,I would get these things looked at.I hope this helps you

You'lll need to put .7 liters of oil on your bike. When you changed the filter, you'll need to add .8 liters of oil.

Hope this helps! i'd appreciate a rating!
-levibit-

Hi,

You have a blown water pump seal, and it is allowing the coolant to mix with the gear oil.
This seal must be replaced or the motor will sieze ant the crank.
Do not run the motor until the repair has been conducted

Cheers

Jon