Removal of air filter - 2002 CCM 604 RS Roadster

Follow the link. BMW 5 Series Cabin Air Filter Micro Filter DIY Replacement Removal And...

Remove hose that comes from engine to filter. Just remove the filter end of air hose, Remove the clamp on filter housing, then pull out filter and replace it. Reinstall the opposite from removal. God-Bless you and your family! Sometimes the air hose sticks to housing so use a screw driver to release it.

Disconnect the spark plug wire from the spark plug and ensure it can't come in contact with the spark plug. Removal of the spark plug wire removes any possibility that power can be supplied to the engine of the blower during the repair.

Remove the screws that hold the air filter cover in place. Remove the air filter cover and air filter. Remove the air filter housing from the side of the machine. Removal of these components allows you access to the primer bulb, fuel line and carburetor.
Repair Procedures for Stihl BR600 Backpack Blower Primer

The filter compartment is at the front bottom of your indoor section of the air conditioner.

There should be an access plate located there and may have a 5/16" screw on each side you need to remove to get the access cover off.

An air filter should be visible, and you should slide the filter out toward you for removal.

hey
No there's no specific special tools required, you can buy oil filter removal tools which are usually a chain that is rapped around it to get grip or a claw type thing. Try to loosen it with your hand first and if that doesn't work you could use a fan belt and vice-grip's or buy a removal tool. the air filter is just a matter of flicking if a few clips.
good luck

Clean your air filter in warm soapy water with a small brush. Rinse after cleaning and allow to fully air dry and then replace.

Looking at the directions....for battery removal, it doesn't state removing the air filter cover but to do that, all you do is unclip the cover of the air cleaner....very simple.

Open the glove box. Remove the damper from the glove box then let the glove box hang down

Remove the dust and pollen filter assembly from the evaporator case.


Remove the filter (A) from the housing (B), and replace the filter.

Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the evaporator

Just give it a firmish pull upward, its held on with spring clips only. The air filters are either side under plastic covers. Youwill need a torxs screwdriver of the correct size