No fire to plugs, i know it has to be a wire that I wired up wrong, somthng wrong because it ran fine before.
SOURCE: Bike won't start. Only hitting on 2 cylendars
Please visit this site for the illustration,
http://www.maxim-x.com/dyna_coils.html
SOURCE: Bike won't start. Only hitting on 2 cylendars
posible vacuum leak replace vac line to fuel tank
SOURCE: 1992 yz125 no spark
Wire may have came off stator or coil
Testimonial: "i have new stators on the way. just checking incase something els could be wrong thanks "
SOURCE: no spark at spark plugs so wont fire
Check the coils first, leaving the key on may have burnt out part of your ignition system.
Easiest way to check coils is to pull one lead off, plug a spark plug into it. Run a hot wire from the positive side of the battery to the coil ( Do Not Plug it in!!) . If you flash the wire on and off the power side of the coil it should make a spark jump across the sparkplug ( don't forget to earth the base of the plug.)
If the coils are ok, see if you can borrow a CDI unit to try in your bike ( it is good to have mates with the same brand of bike )
Don't forget to check all fuses first and make sure the "Kill Switch" on the handlebars is on.
Happy fault finding.
119 views
Usually answered in minutes!
×