What is the torque settings for the peugeot 405 1.9 dt cylinder head bolts

Perhaps you could tell me where the oil filter is situated, Thanks. Sorry I don't know your answer

try asking a service center if you can photo copy the page or use phone take pis of the page. if not try library

no problem the correct setting is ,hmm it says tighten to 20nm then 40nm and then slacken off 130? and tighten 130? ,well this the proverbial brown stuff from a cow to me as when i do these engine i pull down with a speed key then a rachet then my 80cm snap on bar so i suppose iam pulling down to around 75/80 lbs per inch but in all honesty i never use a torque wrench as i used to torque heads in ford of dagenham at 18yrs old so three engine a minute i just sort of feel for the bolt stretch and that it really .

1. Spark plugs removal

1.1. Front cylinder bank spark plugs removal:
1.1.1. Disconnect the battery from car terminals.
1.1.2. Remove the engine plastic cover.
1.1.3. Disconnect the ignition coils electrical supply cable and all three coils connectors.
1.1.4. Remove all three ignition coils screws.
1.1.5. Remove all three ignition coils out from cylinder head.
1.1.6. Remove all three spark plugs out from cylinder head (straight forward).

1.2. Back cylinder head bank spark plugs removal:
1.2.1. Remove the inlet manifold out from cylinder head.
1.2.2. Disconnect all three ignition coils connectors.
1.2.3. Remove all three ignition coils screws.
1.2.4. Remove all three ignition coils out from cylinder head.
1.2.5. Remove all three spark plugs out from cylinder head (straight forward).

2. Spark plugs installation

2.1. Refit all in reverse order.
2.2. Spark plugs tightening torque = 2,8 +/- 0,3 daN.m
2.3. Ignition coils tightening torque = 0,8 +/- 0,2 daN.m

36mm

bolt length 147mm. stage 1, 15nm, stage 2,50nm, 3 slacken off 360 degree, 4 tighten 20nm,5,285 nm, hope this helps, ive checked this on auto data so settings are correct, do it in 5 stages starting from centre and working in a clockwize direction.

I need to know the engine code: but check this manual may be it can help you:
http://www.gigasize.com/get.php?d=dqhcy07n46b

try these websites www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck michigan Man.

hi if i remember rightly its only 8mn..

I understand these cars have a sealed clutch system. When they fail you replace the whole kit master,hydrolic pipe and slave (comes in one piece). Search on ebay maybe £45 or so.