My Ford Fusion 2009 Shows Tier pressure sensor fault. So what is the solution please.

Question edited for clarity.
Question moved to Model Category.

Check the fuses. Oddly, there are two blower components, a relay and a fuse.

Ford Fusion (2006-2009) fuses and relays

https://fuse-box.info > ford > ford-fusion-2006-2009-f...
2008, 2009 - The fuse panel is located below and to the left of the steering wheel by the brake pedal. The location of the fuses in the passenger ...

Slide under the vehicle and locate the speed sensor. On a Ford transmission, the sensor is located on the driver side of the transmission, toward the rear of the unit. The sensor is a magnetic unit that screws into the transmission.

https://www.allcarmanuals.com/factory-service-manual-280-Ford-Territory-SY-SY-II.html

watch this video there will be the answer 2007-2010 https://youtu.be/M-o6bseXNsY

Without diagnostic trouble codes my best guess would be the speed sensor on the transmission is in some way at fault, disconnected or wire broken. The inability to detect output speed on the transmission would prevent, in turn, the ABS from functioning. The ABS module needs to accurately compare speed sensor inputs from transmission and wheel hubs.

WHAT IS A COMPASS ERROR FOR A 2009 FORD FUSION ...

www.fixya.com/cars/t16705785-compass_error_2009_ford_fusion

Feb 21, 2013 - WHAT IS A COMPASS ERROR FOR A 2009 FORD FUSION A MESSAGE COMES UP ON MY DASH SAYS COMPASS NO ... SOURCE: I HAVE A2009 FORD FUSION AND IT'S NOT GOING OVER 20 MPH ... Compass data error -- how do i determine my zone-- ... Jan 28, 2010 ' 2007 Ford Edge SEL Plus.

Compass - Ford Fusion Sport - Ford Fusion Forum

www.fordfusionforum.com/topic/9390-compass/

Jan 23, 2013 - Compass - posted in Ford Fusion Sport: 2011 Fusion SEL without navigation screen. Following windshield ... I have recalibrated and reset the compassaccording to the manual instructions (several times) but cannot correct the error. Can anyone help? ... picture of where it is: 2009-08-30_051718_2.gif.

Here's a link to your sensor. SAVE 20 ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE

All warning lights must be taken serious. Even when the light goes on, because the sensor is defect. Ignoring it and not repair this, makes you also get no warning when the system really fails.
Why the light goes on? could be a real error in the ABS system, could be a sensor problem. Impossible to see from here. Please let a tech check what is wrong and don't wait here for an answer like leave it, or remove the bulb, because that would be ridiculous and irresponsible.

The light should reset itself after driving the vehicle for 10 minutes or so out on the highway.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

The IAT is integrated with the MAF sensor on the 09 Fusion. The MAF is located near the air box on all three engines. on the driver's side, and will be held to some part of the intake tubing by 2 torx screws. http://media.photobucket.com/image/2009%20Fusion%20MAF/itsamecameron/fusion4cylengineMAF.jpg 2.3L shown, 3.0 and 3.5 should be similar.