Replace a fan belt on 1999 AU Falcon - Fairmont Ford Cars & Trucks

https://www.google.com/search?q=fuse+panel+diagram+on+a+1999+isuzu+rodeo?&biw=1364&bih=648&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwjiqb6wxqLRAhVo94MKHfAqB54QsAQIGQ#tbm=isch&q=location+of+fuse+for+the+fuel+pump+in+a+1999+au+falcon+ute

Hope this helps

if genuine au remote.. check the fob battery

could be a faulty door lock actuator or module fault

you will find the free AU falcon repair manual handy
Ford Falcon AU 1998 2002 Workshop Manuals Factory Service Manuals

Disconnect battery take note of the way the drive belt is fitted write it down using cogs as markers then draw the belt onto them in same order (belt only fit one way) then with a 3/8 ratchet leave r the adjuster and remove belt unplug wiring undo bolts holding it to the motor.

have a look under the hood as it probably means that the belt is broken, needs replacing or needs adjustment.

ford park brakes are adjusted by a nut in the brake calliper and then self adjust. Get a ford workshop manual and see how it is done as it is a bit complicated

Locate it at the front harmonic balancer.

had the same problem and had to have computer reflashed at the dealer

Check your belts to be free of debris.
If they are remember that the compressor can go bad also.
Replace it as necessary.Maybe the sound comes from somewhere else .
Listen carefully.

Specs are here : )

http://www.carbuddy.com.au/car/values/specification/viewspecs.aspx?gid=40197&tid=32930188

start by unplugin the electric fans then remove the two 10mm bolts holding them in, the bottom of the fans are held in by a slot that they sit in so after you remove 2 bolts just lift the fans out. then you will see a tensioner i think it has 3/8 drive square hole in it( could be 1/2'' drive) just pull it down with a long bar with a 3/8 end on it to release the tension, while doing that slide the belt of,. if your car doesnt have a picture diaghram on the under side of the bonnet for drive belt routing draw a picture incorprating all the pulleys an how the belt goes around them. once the belt is of put the new one on exept over the power steering pump pulley, then pull on the tensioner again to release tension and slide the belt over the p/s pulley. these instruction are for the 4.0l falcon motor, the 5.0 v8 is really similar