Oil light where is the change oil light reset button on a 2000 alero 3.4L 2 door

On the drivers side there is a fuse panel, you will need to remove the cover and there you will see a reset button. Turn the ignition switch to on and then press the button, the light will flash, then press and hold the reset button until the light goes off, this will also work for the TPS system. Hope that helps

Open the driver door on the car and locate the fuse panel on the SIDE of the dash. Remove panel and there will be a red reset button. Turn key to the ON position and press and release button. Press and hold button again, and you will hear a series of beeps signaling that it has been reset

How to Reset the Change Oil Light

After changing the engine oil, the system must be reset.

With the ignition key to ON, push the RESET button

located in the driver's side instrument panel fuse block. The

CHANGE OIL light will start to flash, press and hold the

RESET button again. The reset is complete when you hear
the chimes sound and the CHANGE OIL light goes out.

turn the key to the "on" position and press the reset button in the fuse panel just inside the drivers door once the change oil light starts blinking press and hold the reset button until you hear a chirp sound and the light goes out.

in the control panel one the right side of the car there is a reset button. all you have to do is turn the car to when all the lights are flashing and hold the reset button until the car dings.

On the left side of the driver door you will see a fuse panel. Open it, turn the ignition to on position, press the reset button once, the light will start flashing, Press and hold the reset button till the light goes out. Note also works for the tire pressure light.

drivers side fuse block, remove cover
1.turn key on (engine off)
2. push the reset button in
3. change oil light will start to flash, press and hold reset button again, reset is complete when you hear the chimes sound and the change oil light goes out

If you mean the change oil soon light............ Open the fuse panel; on the side of the dash by drivers door. turn on key but not far enough to start car.
Press the red reset button in the fuse panel until the oil light flashes , release the button and then press it again.
It has been a while since I have done this on an alero , so if you have your owners manual , it might be a good idea to read the instructions in there incase i have it wrong. By the way , the low tire pressure light works the same way.

After you change your oil you must reset your system to start tracking your next oil change. Simply take off your fuse panel cover. There is a red button in there marked RESET. To do this simply turn your ignition switch on (not started). Then press the RESET button once. You will now see your Change Oil Light blinking. Hold down on the button until you hear it beep. Turn off your ignition switch. Now start your Alero, the light should be off.