Most likely it's like other vehicles and has a carpet lined cardboard cover you must pull down to access the light housing. It doesn't look like there's any type of access into the corners, but you just need to pull the cardboard down to get in. Don't be rough with it, you're going to want to put the carpet covered cardboard back so it still looks good.
SOURCE: replacement of rear outside tail light assembly
If you're asking how do you change a taillight bulb, then follow this procedure:
Open the trunk lid.
Disconnect the connectors from the taillights (taillight bulb connectors are visible by looking inside the trunk at the back of the tail lamps.) There may be an interior trunk trim panel that you have to take off but in most cases its just a series of thumb screws that hold them in.
Brake Lights/Taillights: 21/5 W
Rear Turn Signal Light: 21 W
Back-up Light: 21 W
Rear Side Marker Light: 5 W
Turn the bulb sockets 45 º counterclockwise to remove the bulbs.
If you're removing the taillamps with the bumper off there are 3 nuts and screws that hold the taillight to the rear panel of the car that have to come off from the inside of the trunk.
Remove the nuts and screws, then remove the taillight.
hope that answers your question
SOURCE: Standard Radio Removal Procedure for 2007 Jetta
first you need to remove the top air vent cover,next remove the air vent by unscrewing 3 bolts under that cover.After that you'll see every screw that needs to be removed
101 views
Usually answered in minutes!
×