I plugged in a new radio in my Honda odyssey and it worked at first, i then turned it off and i put electrical tape around the connecting wires and screwed the brackets on and then tried to turn it on again and it didn't work anymore. i then tried plugging the old one back in and it didn't work either??? what happened?? is it a fuse? if so where is the fuse and what would it be named?
SOURCE: 2003 Honda Odyssey Brake light replacement
open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).
SOURCE: P0740 code showing in my 2000 Honda Odyssey
P0740 Torque Converter Clutch Circuit Malfunction
The problem could be the torque converter itself or the sensor circuit for the clutch.
Best to have a Transmission Expert look at it to see if any further damage has occurred.
SOURCE: the timing belt diagram for a honda odyssey 96.
I find that Advance is very helpful on these ?
Testimonial: "thanks. "
SOURCE: how to change plugs on honda odyssey 2005
you will need
8mm
10mm
5/8 spark plug socket
3/8 ratchet
3/8 extension (it could be 4in and longer)
and spark plugs factory plugs are pregap iridium
spark plug torque is 13.0 lb.ft
coil torque 8.7 lbf.ft
spark plug part # NGK 1zfr5k-11
# DENSO pkj16dr-m11
and spark plug anti seize on spark plug thread
what you need to do is remove the plastic cover 8mm socket or 10mm sockets
now remove the spark plug covers and remove the spark plug coils too 10mm head bolt you will need a 5/8 spark plug socket and a 3/8 ratchet and a 3/8's extension too
you need OEM spark plugs they work the best
hope this will help
85 views
Usually answered in minutes!
×