2007 BMW 550i Sedan Logo
A
Anonymous Posted on Jan 04, 2011

I have a 2006 BMW 550i. This morning my Engine Service light came on. While I was backing out of the drive way I noticed I had a lot front end vibration in the engine area which never happens. As I started to press the accelerator to drive forward the front end of the car started to vibrate vigorously as if I were driving over little bumps in the road. This happened around 1and half and 2 thousand RPM's. When the car comes to a stand still it continues to vibrate like I'm in a muscle car. what could this be?

1 Answer

Stewart Dibbs

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 415 Answers
  • Posted on Jan 04, 2011
Stewart Dibbs
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Jan 02, 2011
Answers
415
Questions
0
Helped
147714
Points
716

Sounds like its missing on one cylinder. Could be a failed plug or a blocked injector, or something more serious.

Call your dealer, who will likely suggest that you bring or more likely tow the car to them.

The dealer can scan the ECU for a fault code which will point to an accurate diagnosis.

Testimonial: "Very helpful thank you"

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Bmw 550i 2006 PDC blinking sensor on i-drive

did they du a data stream using a factory scanner-it displays numbrs how each components workin--private shops du this--dont go tu a dealer again they dont keep these machines updated for older cars plus help is unknowledgable-buyin aftermarket electrics is usually troubl-specially w beemers
0helpful
1answer

How reset the flat tire on a 2006 bmw 550i

The tire pressure monitors I have seen require you to drive a certain distance after correcting the low pressure condition.I believe it uses the wheel speed sensors to detect a tire with low pressure(then one that is low will be essentially be giving a different reading because it is rotating more times at a given speed).I am assuming the system IS sensitive enough to get a false reading if one of the tires is a mismatched size,so keep this in mind.
0helpful
1answer

I drive need to reset front brake service light

if its later than a 2005 then its a dealer only job owing to encrypted software
0helpful
1answer

HOW DO YOU RESET THE OIL LIGHT ON A 2006 BMW 550I WITH TAKING IT TO THE DEALER?

Try turn the ignition on...next put foot on the brake....Then mash gas pedal to the floor all the way down until it touches the floor and then back up 3 or 4 times..completely while foot is on brake .This works for GM and chrysler...It might help you I am not sure but it is worth a try.....>Some vehicles have a reset and a settings button on the dash board....If you have these buttons the pedal trick wont work.......Hope this helps.............................Metalpoet
0helpful
1answer

Started driving my car this morning and immediately noticed that the clutch in my 2006 550i bmw felt funny, like it was easy to push. When I try to give it gas when taking off in first gear it shudders...

your clutch is slipping. this may be caused by worn pressure plate, clutch disc or oil seal failure. there are other components that may require attention, such as the clutch master and slave cylinders and fluid level.
0helpful
1answer

Where is the brake fluid fill cap on a 2006 bmw 550i

hi this is normally located to the drivers side bulk head on the servo unit under the hood/bonnet
0helpful
1answer

HOW DO YOU RESET THE OIL LIGHT E60 BMW 550i 2006

Put key fob in. do no hit brake. press start. the bell dings. hold the odometer reset knob found on the left of the speedo. bell dings again. scroll through items/pages with the buttons on the turn signal cruise control signal lever . Select oil hold odometer knob again. It will ask you if you want to reset? you press odometer knob again. Done. Your welcome.
Not finding what you are looking for?

372 views

Ask a Question

Usually answered in minutes!

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...