2006 pontiac montana
I suggest you try one of those instant download manuals. My nephew bought one for me when my car broke and we could fix it all by ourselves with the manual costing $10. This website reliable-store.com is very good for this.
?Try it.
SOURCE: real right turn signal light - Pontiac Montana SV6 2005
If the 2005 Montana is similar to the 2001 Montana, I have a solution. First you'll need a hexagonal wrench (the 6-sided L-shaped wrench). The tail light assembly is held on by two screws. You'll need the hexagonal wrench to remove them, because a normal screwdriver won't do it. I also had to use a conventional adjustable wrench to get the leverage to turn the hexagonal wrench, because the screws were in there pretty tight. Once you remove the two screws, the whole tail light assembly should come off. Mine required a little force and I had to play with it a bit, but it came off without a lot of work. There will be one set of wires that connects the tail light assembly to the rest of the minivan--try not to damage that set of wires. Once you get the tail light assembly off, you'll have to take apart the assembly that actually holds the lights. No tools should be required. It's held on by four plastic catches. Just undo the catches (easier said than done, but still not too tough) and it comes apart. Then you can pop out the old light and pop in the new light. Then re-assemble. For me, it went back together much easier than it came apart.
SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
SOURCE: clunking from front end
CHECK FRONT STABILIZER LINK KITS FOR PLAY.
ONE ON EACH SIDE ATTACHED TO STRUTS.
SOURCE: Changing the front brake pads on a 2006 Pontiac Montana SV6
Use a z clamp,Or us big azz pliers,Or use a hammer handle and put one of the old pad in and put the hammer handle in the and twist it will work.I hope this helps
SOURCE: Pontiac Montana SV6
For instructions on how to program remotes and keys check website below, I use these and they are usually very accurate. This website does state that on your vehicle, special equipment is needed to program a key fob, as there is no onboard programming for it. However, there are programming instructions for transponder keys.
http://www.programautokeys.com/
http://www.programautokeys.com/
200 views
Usually answered in minutes!
×