SOURCE: Replaced rear axle pinion bearing and seal, need
There is no torque specs,this nut has to be tightened back like it was ,the best thing to do,was,to late now,is to use a torque wrench to remove the nut,and remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pion bearing ,and the rear pinion bearing,and it has to be crushed to a certain amount,to aquire deepness into the ring gear,anyway just give it about 25 lbs torque,any more the crush sleeve will crush even more and the deepness of the pinion will be too much.
SOURCE: What are the torque specs
the torque are not mention out side any authorised workshop for that you need to visit the nearest authorised dealer or service centre & leave the rest of work to them without any hazard or trouble or either can start from a torque of 25 to 45 lbs. do not exeed the limit or other wise the nut or even the Axel can get broken in the prossess of facinating it so till then my friend have happy motoring & see you soon.!
SOURCE: torque specs on replacing cv axle on 05 Pacifica
ok here we go tie rod=55 ft lbs axel nut= 180 ft lbs strut bolts= 65 ft lbs plus 90 degrees
Testimonial: "thank you very much!!!!!!!!!!"
4,411 views
Usually answered in minutes!
front or rear
×