2006 ISUZU I-280 EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH Recall Date: 04/27/2006 Summary: CERTAIN PICKUP TRUCKS MAY EXPERIENCE THE PERMANENT LOSS OF BRAKE LAMP FUNCTION OR BRAKE LAMPS THAT ARE ILLUMINATED AT ALL TIMES. THE CENTER HIGH-MOUNTED STOP LAMP (CHMSL) IS AFFECTED IN BOTH INSTANCES. ALSO, IF EQUIPPED, THE CRUISE CONTROL WILL BECOME INOPERATIVE. ANY TRAILER BRAKE LAMPS WHICH ARE CONNECTED TO THE VEHICLE'S BRAKE LAMP WIRING WILL MIMIC THE VEHICLE'S BRAKE LAMPS WHEN EITHER CONDITION OCCURS. Consequence: A FOLLOWING DRIVER MAY NOT KNOW WHEN THE BRAKES HAVE BEEN APPLIED, AND A REAR-END CRASH COULD OCCUR WITHOUT PRIOR WARNING. Remedy: DEALERS WILL REPLACE THE BRAKE LAMP SWITCH ASSEMBLY. THE RECALL BEGAN ON DECEMBER 5, 2006. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438; GMC AT 1-866-996-9463 OR ISUZU AT 1-800-255-6727. Potential Units Affected: 404733 Notes: ISUZU I-280 06030
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hey I don't mean to condemn your car, but what you have is a GM vehicle not a real Isuzu. The real Isuzu was a lot more easier to work with and much more pleasant to drive in my opinion. Anyway, there are a few screws holding the armrest and the door handle plastic flange that needs to be removed first. Then you can pop off the door panel, which is just snap fitted. You might have to look hard for the screws and even use a flat screwdriver pop off the small plastic pieces hiding the screw heads. Make sure you don't try to pop off the panel before removing the screws as this will irrepairably damage the panel.
Description
AN INTEGRATED CIRCUIT WITHIN THE VOLTAGE REGULATOR CAN CONTAIN MANUFACTURING ERRORS.
Consequence
THIS CAN CAUSE EXCESSIVE ELECTRICAL CHARGING OF THE VEHICLE'S
ALTERNATOR, RESULTING IN ENGINE CONTROL MALFUNCTION, AND/OR EVENTUAL
ENGINE STALL.
Remedy
DEALERS WILL REPLACE THE VOLTAGE REGULATOR WITH A NEW REGULATOR.
jehr
×