Questions & Answers for: chmsl

...a ford e-150 2006 with no break light problem & the mechanic can't trace the problem. Does the CHMSL ( Center High Mount Stop Lamp ) work ? If this does not work, check the BPP ( Brake Pedal ...

bought my 1999 blazer used missing the chmsl fuse in the fuse block under the hood is it needed also does it have anything to do with 4x4 thanks mike The chmsl fuse is for the third brake light. There

...Negative battery cable Open the hatchback door Pry open the center high-mounted stop lamp (CHMSL) access cover with a trim removal tool Electrical connector Screws and the CHMSL To Install: ...

...decklid latch and open decklid.From under rear shelf panel, disconnect the lamp socket from the CHMSL housing. Remove bulb from the socket.INSTALLATION Install the bulb into the socket. Install ...

chmsl fuse keeps blowing out CHMSL belongs to the third eye brake light this is known as the center high mounted signal light you may need a third eye light socket for start hope this is your solution

2002 blazer with tow package chmsl wont work I'm not sure what chmsl   are need to claify

...positive voltage is supplied to both the STOP 15-amp fuse and the center high mounted stop lamp (CHMSL) 10-amp fuse in the instrument panel (I/P) fuse block, and to the turn signal/hazard module. ...

...work. All the bulbs are good. How do I start to trouble shoot this problem? Have you checked the CHMSL fuse in the under hood fuse box ? It is a 10 amp . CHMSL - center high mount stop lamp fuse

...applying battery voltage through the STOP LP fuse to illuminate the center high mounted stop lamp (CHMSL). Ignition OFF, disconnect the stop lamp relay. Ignition OFF, exterior lamps OFF, test for ...

...a input to the BCM - body control module ,the BCM turns on the stop lamps . Possible short in the (CHMSL ) - center high mount stop lamps , wiring etc.... Causing problem inside the BCM . Do you