What is the order of the spark plug wires for my 1994 isuzu?

Pontiac Trans Sport firing order diagram spark plug wires ...

www.fixya.com > ... > Cars & Trucks > Pontiac
Pontiac Trans Sport cars & trucks firing order diagram spark plug wires questions and answers. ... 1994 pontiac transport se not firing in first coil pack at idle. images for 1994 Pontiac transport timing sequence

1342 thats right!!

is every thing hooked up(wiring to dist.) check good if forgot a plug connector

The sensor should be right there where the intake air duct meets the air filter housing.
That oil down in the spark plug tube is most likely from a leaking valve gover gasket. Oil in there can and will cause misfires.

FIRING ORDERS NOTE: To avoid confusion, remove and tag the spark plug wires one at a time, for replacement. If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes in your book to reflect how your engine is wired. Fig. 1: 1.8L, 2.0L and 2.3L engines Firing Order: 1–3–4–2 Distributor Rotation: Counterclockwise
Fig. 2: 2.6L and 2.8L engines Firing Order: 1–3–4–2 Distributor Rotation: Clockwise
Fig. 3: 3.1L engine Firing Order: 1–2–3–4–5–6 Distributor Rotation: Counterclockwise
Fig. 4: 3.2L engine Firing Order: 1–2–3–4–5–6 Distributorless Ignition System

the rubber gasket is probably in the socket.

They are at the end of spark plug wires in the engine

1-3-4-2

In the center of each valvecover is a well with a wire in it each wire has a seal cap attached pull up and youll find a stem which goes down a tube this is part of the spark plug wire the plugs are at the bottom of this tube youll need a long adapter on your wrench and socket for this job and you can extract the plug using the wires stem

Hi,

On the 3.2L distriburorless ignition, the firing order is a straight 1-2-3-4-5-6.

Cylinder numbering .

-

Hope this works for you