How to remove a starter motor on a renault megane 1.6 16 valve v reg

SOURCE: renault megane scenic ( t-reg)

MY SCENIC WAS LEAKING THROUGH THE BUTTONS THAT control the SUNROOF. after many months of hair tearing i found the solution. The black sealant used to seal the windscreen on the inside was hard and dried out with age. I bought some new sealant - re sealed the windscreen on the inside top part. Hey presto. no more wet seats and footwells

Colin Stickland

• 22516 Answers
• Posted on Nov 23, 2008

SOURCE: Renault Megane key will not open doors

work it manually and it should work ...ie put the key in the door and open and lock the door 3 times slowly then jump in and try to start within 15 secs .if it doesnt work then be prepared to be fleeced and lay the golden egg at the dealers

SOURCE: inner door panel removal, renault megane scenic

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

SOURCE: My Renault Megane Scenic S reg heater is not working

Most likely to be a faulty resistor block, which has 3 resistors and a thermal fuse controlling fan speeds 1,2 and 3, maximum speed 4 by-passes the resister block. It may also be poor electrical connections to the resistor block caused by overheating. Renault ask for approximately £350 to carry out repairs, a replacement resistor block will cost £50. If you decide to carry out the repairs yourself, be advised that if you are not competent to carry out such work you, could cause electrical damage or worse an electrical fire.

SOURCE: starter motor removal

Dissconnect the battery .the starter is located on the gearbox facing into the flywheel. you need to remove any connectors that are on the back of the starter then take the bolts out that hold it on give it a little shake and it should come out.