Remove front door panel 1999 olds aurora - 1999 Oldsmobile Aurora

which door. most have a pin that you have to use a punch to hit out. some have 4 bolts. if its a 4dr look at the rear doors to see what style they have

If you can't open the door you can pull the corresponding seat to gain access and remove the inner door panel

Find security answers on this link

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Under the intake manifold. You need to remove the fuel rails and manifold to get to it. Not too difficult (about 2 hours)

This may not be your answer but I had a similar issue a few years ago and had to have a body shop get into the door and replace the handle and linkage. Someone, a child, tried to open the door while locked. He was strong enough and/or handle weak enough that it broke. The door could be opened from the inside handle normally. Cost me about $180 for part, install and repaint to match.

Normaly it is under the hood on the drivers side under a plastic cover but it should easy to see and remove. If it is not there look at your fuse panel and at the top is another place ther have ther turn signal relays.

You might want to take it to a glass shop. You have to take off the inside door panel and find all the screws to do this. Then if it is the drivers door you have to remove any electric switches to remove this panel. Then remove old regulator from motor and put in the new parts. I usually use a piece of wood and a clamp to keep the glass from falling. A glass shop can do it within an hour and you don't have to chase parts.

front

SECTION 501-05: Interior Trim and Ornamentation 1999 F-Super Duty 250-550 Workshop Manual
REMOVAL AND INSTALLATION Trim Panel —Front Door Removal

1. Remove the rear view mirror mounting hole cover (17K709).

1. If equipped, remove the window regulator handle (23342); refer to Section 501-11 .

1. If equipped, remove the window regulator switch plate (14524); refer to Section 501-11 .

1. If equipped, disconnect the power windows, power door lock switch and power mirror connectors.

1. If equipped, remove the front door trim panel reflector or the courtesy lamp lens.

1. Remove the screws.

1. NOTE: Remove the front door trim panel (23942) by pulling it straight upward.
   Lift and remove the front door trim panel.

1. If equipped, twist the courtesy lamp connector one half turn and remove it from the front door trim panel.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door