I have a 1993 Volvo 240, w/ auto trans, the shifter is loose, I can see a bolt that must be installed from below, how do I get to the bolt to tighten it?
I have owned several 240's (i drive a 1990 245 at the moment) and have had this problem in the past. it is not a bolt that you have to replace, it is the shifter-link bushings and the c-clip on the bottom of the shifter-link. if you jack your car up and place the jack stands at the front jack points so you can scout underneath the car. at the front end of the transmission (where the O.D. selanoid wire comes out of the body) is the shifterlink and in the shifter-link should be 3 holes (there should be 3 bushings in there and a c-clip keeping it all together), replace the c-clip and bushings and i promise that your shifter will be VERY TIGHT. good luck :)
807 views
Usually answered in minutes!
×