SOURCE: There is no sensor on
around the bellhousing where it can access the flywheel is the most logical ,have you had a good look at the engine and looked at both front pulley and the bellhousing first though before asking?but some vehicles do have them in the block level with the craknshaft ,just have a good look and you will no doubt find it
SOURCE: Crankshaft Position Sensor location 04 PT Cruiser
It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.
SOURCE: were i the crankshaft position
near the oil filter.. above it...under exhaust manifold one small bolt holds it on. If the is a no start condition look for frayed wiring near crank sensor..... it has a harness that hangs too low on some of those. & rubs on cv shaft
SOURCE: whats the position of the crankshaft position sensor on 2005 pt cruiser non turbo
P0344 CHRYSLER - Camshaft Position Sensor Intermittent Interruption Bank 1 Sensor 1
Possible causes
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty starter motor
- Starting system circuit
3,680 views
Usually answered in minutes!
×