At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
are you sure that is the code I have nothing on that verify and get back to me plz the closest i got was air temp failure but code was P0112are you sure that is the code I have nothing on that verify and get back to me plz the closest i got was air temp failure but code was P0112
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The description for diagnostic trouble code (DTC) P2112 is, "Throttle Actuator Control System - Stuck Closed." This DTC sets when the fault status indicates that the throttle plate is at a lower angle than commanded. There are three areas where the fault could be; a mechanical problem with the throttle body (physically stuck closed or binding at a certain position), a wiring issue (circuits are either open or shorted between the throttle body and PCM) or a faulty Powertrain Control Module (PCM). Considering the throttle body has already been replaced, it is unlikely for the new part to have a mechanic issue although not impossible, especially if a salvage/used component was installed. In my experience PCMs are rarely the cause, therefore I would highly suspect a wiring issue. I'd recommend performing a visual inspection of the engine wiring harness for any damage caused by heat from the exhaust, rodents or poor repairs performed in the past. Be sure to inspect the connector to the throttle body as well as the connector pins to ensure they haven't been bent over, corroded or broken. You can read more about the P2112 DTC here: https://www.yourmechanic.com/article/p2112-obd-ii-trouble-code-throttle-actuator-control-system-stuck-closed-by-spencer-clayton
what is code when you get the code or if know it online search just code and you will see multi sites for code most of them will tell causes and also how to repair
Looking up that code by number lists it as this P2112 DODGE Throttle Actuator Ctrl Mod Processor,, I know on some VW's the coding is different,, so I'll try and see if that code is the same for your car
code p2111 throttle actuator control system actuator stuck open. throttle actuator control system circuit malfunction. brake vacuum implausible signal. code p2112 throttle actuator control system actuator stuck closed.throttle actuator control system circuit malfunction. code p2135 accelerator pedal position sensor switch a b voltage correlation. throttle position sensor switch a b voltage correlation. electronic throttle position sensor switch 1 implausible signal. did not see code p210406 that code too long.
P2111 - Throttle Actuator Control System Stuck Open. P2112 - Throttle Actuator Control System Stuck Closed. P2238 - O2 Sensor Positive Current Control Circuit Low Bank 1 Sensor 1
For the P2111 & P2112 you will need to replace the throttle body this can be pricey since the TAC is built into it. Try cleaning it good and see what happens. This can also trigger the P2238 code if its dumping fuel. For the P2238 check the connections on the o2 sensor or replace the upstream o2 sensor that should correct it.
check the hose on the intercooler and around the turbo, check for split on turbo and the intercooler hose not too soft as they can collaps while driving
are you sure that is the code I have nothing on that verify and get back to me plz the closest i got was air temp failure but code was P0112
×