Where is the location of the crankshaft positioning sensor on a 1994 dodge caravan van

have vehicle scanned for any codes and before throwing parts at it start with basics --test battery was fine is not a diagnosis of its condition check and test connections --fuses --relays ignition switch --key
------- https://www.youtube.com/watch?v=L-JV8C3OvfI

Location of crankshaft sensor on dodge caravan 1994

The crankshaft position sensor mounts to the engine block behind the alternator near the oil filter.

1996 Dodge Truck Caravan 2WD 3.0L MFI 6cyl

The Crankshaft Position Sensor is located:Under hood, driver side, rear engine area, mounted top rear of engine .click here and enlarge picture,it's number 9,send picture to your library and you can enlarge even more.Here's the part.Here's how to remove.

According to Haynes, the V6 engine has the sensor mounted in the bellhousing on the back of the engine.

Hi there:
The 3.3/3.8L crankshaft sensor is located on the rear of the transmission housing, above the differential housing (The bottom of the sensor is positioned next to the drive plate...






Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

camshaft position sensor high input, camshaft position position sensor intermittent, ignition coil circuit. Check your circuits to these locations. also check for cracks and breaks.

For 1991 Dodge Truck Caravan 4WD 3.3L MFI 6cyl the Crankshaft Position Sensor is located: Under hood, center, rear engine area, where transaxle bellhousing meets engine, mounted in engine block.

Hope this Helps (remember to rate and comment this).

located on the transmission in the rear of the engine where the engine and trans bolt together small cyinder with a ribbon wire coming from it

Sounds like an AUTOMATIC SHUTDOWN (ASD) RELAY problem. Fairly common on the Caravan.
Heres a brief overview of the ASD.
The Powertrain Control Module (PCM) operates the Auto Shutdown (ASD) relay by switching the ground path on and off.
The ASD relay supplies battery voltage to the fuel injectors, electronic ignition coil and the heating elements in the oxygen sensors.
The PCM controls the relay by switching the ground path for the solenoid side of the relay on and off. The PCM turns the ground path off when the ignition switch is in the Off position unless the 02 Heater Monitor test is being run. Refer to On-Board Diagnostics. When the ignition switch is in the On or Crank position, the PCM monitors the crankshaft position sensor and camshaft position sensor signals to determine engine speed and ignition timing (coil dwell). If the PCM does not receive the crankshaft position sensor and camshaft position sensor signals when the ignition switch is in the Run position, it will de-energize the ASD relay.
The ASD relay is located in the Power Distribution Center (PDC). The PDC is located on the driver's side inner fender well Power Distribution Center . A label on the underside of the PDC cover identifies the relays and fuses in the PDC
Check for good ground.
Good luck...i hope this helps, please rate me a fixya.