ON my 1994 jeep Cherokee country when I turn either turn signal, both turns and the bright light indicator flash,and I have no head or tail lights?

TAIL LIGHT NOT WORKING

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.

---------

There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----

Turn Signal Not working

http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------

Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------

Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------

Turn signals not working on 1987 Jeep Wagoneer?

http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE

http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------

1994 Toyota Camry: Bypass Tail light Relay Circuit?

http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------

2008 Toyota RAV4: Replace Tail light Lens Cover?

http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html

--------

2003 Chevrolet S10 Tail light Fuse

http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------

Chevrolet Parking light and Tail lamp light Wiring diagram

http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------

Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------

These details will help.

Thanks.

Then you need someone who can,like a repair shop

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.


---------
There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----
1994 Toyota Camry: Bypass Tail light Relay Circuit? http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------
2008 Toyota RAV4: Replace Tail light Lens Cover?

http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html
--------
2003 Chevrolet S10 Tail light Fuse http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html
--------- Chevrolet Parking light and Tail lamp light Wiring diagram http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html
---------- Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------
Turn Signal Not working http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html
---------- Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------
Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------
Turn signals not working on 1987 Jeep Wagoneer? http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------
Thesedetails will help.
Thanks.

Replace the turn signal switch. They started running all the lights threw it. They call it the multifunction switch now.

If it happened the way you described it. I don't see how it could possibly have damaged anything. I guess what you are saying is that the left tail lights are not working? ("4 way exterior dim lights"???) Touching the tail light wire to the turn signal wire will only cause your turn signals to light up. (I am assuming that the tail light switch was on at the time)
I think it is more likely that the brown wire touched ground. This would make a bright flash, blow a fuse and cause the symptom you are describing...I think you need to check the fuse again.
There are separate fuses for the left and right sides. The left side tail lamp fuse is fuse #7 in the junction block it is a 10 Amp fuse. The junction block is located on the right cowl side inner panel - We are NOT talking about the Power Distribution Center under the hood.

All of the above is also assuming that we are talking about a plain Cherokee, Cherokee SE, Cherokee classic or Cherokee Limited.

If we are talking about any of the Grand Cherokees, you may have a fried lamp outage module.

That does not make any sense. Do the tail lights work? There are supposed to be separate filaments for brake lights, tail lights, and turn signals. In particular the center brake light should not be possible to be confused with tail lights or signals. Does it come on? If not, then you probably have no brake lights at all, and that is probably because of the bad fuse or the switch on the brake pedal for the brake lights.
If there is some sort of cross over between tail light and brake lights, that is usually from a bad light socket ground; which results in current backing up from one system to another. But then each is usually only half brightness.

the driver information center(DIC) is telling you one or more of your rear light bulbs has failed. it could be a tail light,stop light,center high mount stop light,turn signal or license plate light. have someone in the vehicle turn the lights on and hit the brakes and turn signals so you can see which one is burned out.

Hello and welcome to FixYa . Locate the dial that controls the brightness of the dashboardlights. If the control is not immediately evident. Make sure the brightness control is turned on. If it is and the lights aren't working, the problem may be a bad fuse. Check the fuse that controls the dashboard lights Replace the fuse if necessary. If just one part of the instrument panel is not lighting up, then you have either a burned-out bulb or a wiring problem.

Passenger side kick panel fuse breakdown for a 1996 jeep Cherokee Country

01 - 25A Rear Wiper/Washer
02 - 15A Radio, Cigar Lighter
03 - Empty
04 - 15A Passing Light
05 - 30A Blower Motor
06 - 30A (Circuit Breaker) Power Windows
07 - 02A ABS
08 - 20A Turn Signal Flasher
09 - 10A Radio/Clock Memory, Courtesy Lights, Glove Box, Cargo, Dome Lights, Telltales
10 - Empty
11 - 25A Headlamp Delay Module, Horn
12 - Empty
13 - 20A Power Door Locks
14 - Empty
15 - 15A Instrument Panel Lamps, Clock/Radio and Memory, Headlamp Switch, Parking Lamps
16 - 30A (Circuit Breaker) Power Seats, Trailer Tow
17 - 7.5A Instrument Cluster Gauges, Headlamp Delay Module, Chime Module, Overhead Console
18 - 25A Rear Defrost
19 - 05A Instrument Panel Lamps, Radio Illumination
20 - 5.5A (Circuit Breaker) Windshield Wipers and Washers

This should get you going. And you can always Ask Me.

this is a fuse I honestly believe check them with ohm meter. Lots of cars if you have a tail light out the dash light will not function also. I hope this helps

There is a breaker in your circuit box it is silver mine did the same thing and i had a loose wire on my head light switch and my breaker was blown...