PEUGEOT 206 HDI STARTING PROBLEM

Sounds like you might need to replace the starter.

yes put key inignition turn to first turn at the end of the indicator stalk there is a button press and hold in until it displays and makes beeping sound same scenario to turn back on

have heating in my peugeot 406 hdi when car is ticking over but when i drive for few mins the heater goes cold

Peugeot 206 1.4 HDi - DV4TD (8HZ) 2004 ...

1. The serpentine belt routing diagram - without A/C (Air Conditioning)




2. The serpentine belt routing diagram - with A/C (Air Conditioning)

In my opinion cut off problem occurs if engine is not getting sufficient fuel and/or air. Clean the air filter, turbo filter and fuel filter. Check the continuity of diesel flow from filter to hdi pump. If you haven't found any problem there then the possibily the hdi pump and injectors section needs to be checked. If the car has done more than 100000 miles then clean inlet and outlet manifolds including check of turbo and EGR valve. Do everything whatever possible before you take your car to garage. If there is no luck then let your car diagnosed and check any error code recorded by ecu.

check the glow plug relay on the bulk head they are known for failing due to water ingress
also you may want to get the crank position sensor checked

if its diesel 2000 hdi .........its under the hdi cover under the bonnet

if its a 1400 hdi.........
its to the right of the air filter at the back of the engine

glow plug light should just flicker as not needed until -6 stop light stays on when off until started

have you tried the glow plug relay? or if you have a test light see if theres power to glow plugs when light is on,should only light for 5 or so seconds.some of the newer hdi dont even use the glow plugs till temp is very cold,i have a 2006 2.0 hdi van and glow plug light only stays on for a second or so,and its been like that from new! is the problem just bad starting? and is it only when its cold? if you have a manual priming pump for fuel under bonnet,trying pumping before starting it could be fuel prob?ie air getting into fuel system